The effects of cryogenic cooling on chips and cutting forces in turning AISI 1040 and AISI 4320 steels

Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture

Volumn 216, Issue 5, 2002, Pages 713-724

  Dhar, N R ^a   Nanda Kishore, S V ^a   Paul, S ^a,b   Chattopadhyay, A B ^b  

^a Technical Teachers Training College   (Bangladesh)

^b INDIAN INSTITUTE OF TECHNOLOGY   (India)

Author keywords

Chip formation; Cryogenic cooling; Cutting forces; Cutting temperature; Turning

Indexed keywords

COOLING; CUTTING FLUIDS; LOW TEMPERATURE PHENOMENA; MACHINABILITY; TURNING;

CHIP FORMATION; CRYOGENIC COOLING;

STEEL;

EID: 0036271809     PISSN: 09544054     EISSN: None     Source Type: Journal    
DOI: 10.1243/0954405021520409     Document Type: Conference Paper

References (32)

1. The effect of cutting fluid upon chip-tool interface temperature
2. The physical chemistry of cutting fluid action
3. Lubrication action of cutting fluids
4. Temperature and wear of cutting tools in high speed machining of Inconel 718 and Ti-6V-2Sn
5. Metal machining with high pressure water-jet cooling assistance - A new possibility
6. The effects of a high pressure coolant jet on machining
7. Machin-ability studies on steel using hard metal inserts with soft material deposit
8. Hard turning with minimum cutting fluid: A viable green alternative on the shop floor
9. Improvements in grinding steels by cryogenic cooling
10. Effects of cryo-cooling in grinding steels
11. Effects of cryogenic cooling by liquid nitrogen jet on forces, temperature and surface residual stresses in grinding
12. The effect of cryogenic cooling on grinding forces
13. Determination and control of grinding zone temperature under cryogenic cooling
14. Application of cryogenic in metal machining
15. Chip formation, surface rough-ness, cutting forces and tool wear in cryogenic machining
16. Mechanisms of tool wear
17. Face milling at 180 °C
18. Cryogenic diamond turning of stainless steel
19. Characteristics of micro wheel wear in grinding
20. Improvement of chip breaking in machining low carbon steel by cryogenically precooling the workpiece
21. Economical cryogenic milling for environmentally safe manufacturing
22. Wear of CBN tool in turning of silicon nitride with cryogenic cooling
23. 4)
24. An analysis of cutting tools with negative side cutting edge angles
25. A study of chip surface characteristics during the machining of steel
26. Role of cryogenic cooling on cutting temperature in turning steel
27. Cutting angle relationship on metal cutting tools