Adiabatic shear banding in high speed machining of Ti-6Al-4V: Experiments and modeling

International Journal of Plasticity

Volumn 18, Issue 4, 2002, Pages 443-459

  Molinari, A ^a   Musquar, C ^a   Sutter, G ^a  

^a UNIVERSITÉ DE LORRAINE   (France)

Author keywords

Adiabatic shear banding; High speed cutting; Titanium alloy

Indexed keywords

CUTTING; THERMAL CONDUCTIVITY; TITANIUM ALLOYS; WEAR OF MATERIALS;

ADIABATIC SHEAR BANDING; HIGH SPEED CUTTING;

MACHINING;

EID: 0036008427     PISSN: 07496419     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0749-6419(01)00003-1     Document Type: Article

References (21)

1. The temperature and strain-rate dependence of the shear strength of mild steel
2. New observations on the mechanism of chip formation when machining titanium alloys
3. Titanium, a model material for analysis of the high-speed machining process
4. Some clarifications on the mechanism of chip formation when machining titanium alloys
5. Study on machining of titanium alloys
6. Machining of titanium alloys
7. L'usinage du titane et de ses alliages
8. Machining of titanium and it's alloys
9. A model for fully formed shear bands
10. An experimental technique for shear testing at high and very high strain rates. The case of mild steel
11. Some metallurgical aspects of chip formation in cutting Ti-6wt.%Al-4wt.%V alloy
12. A scaling law for the effect of inertia on the formation of adiabatic shear bands
13. A note on the problem of shear localization during chip formation in orthogonal machining
14. Collective behavior and spacing of adiabatic shear bands
15. Experimental analysis of cutting process and chip formation at high speed machining
16. Modeling of orthogonal cutting with a temperature dependent friction law
17. An experimental study of high speed orthogonal cutting
18. Structure of adiabatic shear bands in thermo-viscoplastic materials
19. Chip formation at titanium alloys under cutting speed of up to 100m/s