Deformation behaviour of sheets of three aerospace Al-alloys

Journal of Materials Processing Technology

Volumn 112, Issue 1, 2001, Pages 68-77

  Date, P P ^a   Padmanabhan, K A ^b  

^a INDIAN INSTITUTE OF TECHNOLOGY BOMBAY   (India)

^b INDIAN INSTITUTE OF TECHNOLOGY KANPUR   (India)

Author keywords

Aerospace Al alloys; Forming limit diagram; Punch stretching; Sheet metal formability; Strain distribution in sheet forming; Void formation in forming

Indexed keywords

ALUMINUM ALLOYS; METALLOGRAPHIC MICROSTRUCTURE; STRAIN; STRETCHING; SURFACE ROUGHNESS; TENSILE PROPERTIES; THERMAL EFFECTS;

FORMING LIMIT DIAGRAMS (FLD);

SHEET METAL;

EID: 0035799746     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0924-0136(01)00547-7     Document Type: Article

References (17)

1. On the formability of 3.15 mm thick low-carbon steel sheets
2. Hill's plastic strain ratio of sheet metals
3. The variation of plastic anisotropy during straining
4. Room temperature formability and fracture behaviour of a high strength Al-Zn-Mg alloy
5. Modification of cast structures in aluminium-magnesium alloys by thermal treatments
6. The deformation of commercial aluminium-magnesium alloys
7. Enhanced ductility in an aluminium-4 pct magnesium alloy at elevated temperature
8. The effect of precipitation hardening on dynamic strain aging and jerky flow
9. Formability of aluminium alloy sheets
10. On the directionality of strain localisation when stretching aluminium alloy sheets in biaxial tension
11. On the prediction of the forming limit diagram of sheet metals
12. A journey without maps: A brief account of some solutions in plasticity and superplasticity
13. Influence of punch curvature on the stretching limits of sheet metal
14. Stretching limits in sheet metals: In-plane versus out-of-plane deformation