Evaluation of a prototype thermal anemometer for use in low airspeed drying measure calculations

Flow Measurement and Instrumentation

Volumn 12, Issue 5-6, 2002, Pages 385-396

  Martin, D P ^a,b   Grant, J J ^b   Ringwood, J V ^a  

^a NATIONAL UNIVERSITY OF IRELAND   (Ireland)

^b TEAGASC   (Ireland)

Author keywords

Anemometry; Drying measure; Mushroom; Thermal compensation; Wind tunnel

Indexed keywords

DRYING MEASURE APPLICATION;

ATMOSPHERIC HUMIDITY; CALIBRATION; ERROR DETECTION; LOW TEMPERATURE DRYING; VAPOR PRESSURE; WIND TUNNELS;

ANEMOMETERS;

AIRFLOW; ANEMOMETER; DRYING; MEASUREMENT METHOD; PROTOTYPE;

EID: 0035742049     PISSN: 09555986     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0955-5986(01)00033-4     Document Type: Article

References (29)

1. Air circulation in mushroom houses
2. Evaporation power of air
3. Mushroom-house ventilation: Use and misuse
4. Design of an air-speed sensor system
5. Laboratory testing of humidity sensors for use in animal environments
6. Comparison of temperature correction methods for hot wire anemometers
7. Effect of fluid temperature on hot-wire anemometers and an improved method of temperature compensation and linearisation without use of small signal sensitivities
8. The temperature sensitivity of hot wires
9. Improved calibration of hot-wire anemometers
10. Velocity calibration relationships for hot-wire anemometry
11. Spatial homogeneity of air in a mushroom tunnel: Single vs. boost duct air distribution systems
12. Hot-wire anemometer thermal calibration errors
13. Impact of velocity and temperature fluctuations on the accuracy of low velocity measurements indoors by thermal anemometers
14. A tower-mounted calibrator for hot-film anemometers
15. Impact of natural convection on the accuracy of low velocity measurements by thermal anemometers with omnidirectional sensor
16. Requirements and guidelines for low velocity measurements
17. Draught and air velocity measurements
18. Integration time needed for determination of reproducible air velocities in a ventilated room
19. Determination of acceptable sampling rates for recording wind-speed data
20. A thermoelectric sensor for fluid flow measurement: Principles, calibration and solution for self temperature compensation