Influence of processing conditions and part design on the gas-assisted injection molding process

Advances in Polymer Technology

Volumn 20, Issue 4, 2001, Pages 270-280

  Ong, Nan Shing ^a   Lee, H L ^a   Parvez, M A ^a  

^a NANYANG TECHNOLOGICAL UNIVERSITY   (Singapore)

Author keywords

[No Author keywords available]

Indexed keywords

BENDING STRENGTH; BUBBLE FORMATION; GASES; PRESSURE; SHRINKAGE; THERMAL EFFECTS; THICKNESS MEASUREMENT;

FINGERING; GAS ASSISTED INJECTION MOLDING PROCESS; GAS BUBBLE LENGTH; GAS DELAY TIME; SHOT SIZE; SINK MARKS; WARPAGE;

INJECTION MOLDING;

EID: 0035576718     PISSN: 07306679     EISSN: None     Source Type: Journal    
DOI: 10.1002/adv.10000     Document Type: Article

References (7)

1. An experimental study to investigate the influence of processing conditions in the gas-assisted injection molding process
2. An investigation of gas-assisted injection molding: Effects of process variables on gas bubble formation
3. A study of fingering phenomena in the gas-assisted injection molding process: The effects of processing variables and the fluidity ratio