Process modeling in machining. Part I: Determination of flow stress data

International Journal of Machine Tools and Manufacture

Volumn 41, Issue 10, 2001, Pages 1511-1534

  Szymura Oleksiak, J ^a   Losarczyk A ^b   Cios, A ^a   Mycek, B ^a   Paszkiewicz, Z ^b   Szklarczyk, S ^c   Stankiewicz, D ^c  

^a JAGIELLONIAN UNIVERSITY   (Poland)

^b AGH UNIVERSITY OF SCIENCE AND TECHNOLOGY   (Poland)

^c JAGIELLONIAN UNIVERSITY MEDICAL COLLEGE   (Poland)

Author keywords

[No Author keywords available]

Indexed keywords

COMPUTER SIMULATION; MATHEMATICAL MODELS; METAL CUTTING; PLASTIC FLOW; PROCESS ENGINEERING; STRAIN RATE; STRESS ANALYSIS;

HOPKINSON BAR METHOD; ORTHOGONAL SLOT MILLING;

MILLING (MACHINING);

EID: 0035427828     PISSN: 08906955     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0890-6955(01)00016-5     Document Type: Article

References (32)

1. The behavior of some steels under dynamic compression
2. Mechanics of machining - From descriptive to predictive theory
3. Flow stress of low carbon steel at high temperature and strain rate (Part 2)
4. Flow stress of low carbon steel at high temperature and strain rate (Part 1) - Propriety of incremental strain method in impact compression test with rapid heating and cooling systems
5. Simulation analysis of machinability of leaded Cr-Mo and Mn-B structural steels
6. Computational machining of titanium alloy - Finite element modeling and a few results
7. Experiments on and finite element modeling of turning free-cutting steels at cutting speeds up to 250 m/min
8. High-temperature deformation behavior of Ti6Al4V alloy evaluated by high strain-rate compression tests
9. An experimental investigation of the influence of strain rate and temperature on the flow stress properties of a low carbon steel using a machining test
10. Computer simulation of orthogonal cutting processes: Determination of material properties and effects of tool geometry on chip flow
11. Inter-relationship between shear processes occurring along tool face and shear plane in metal cutting
12. Determination of rake stress distribution in orthogonal machining
13. Determination of stress distribution on the tool rake face using a composite tool
14. Introducing strain-rate dependent work material properties into the analysis of orthogonal cutting
15. Analytical modeling of drilling and ball end milling
16. Mechanics of metal cutting processes
17. Predicting the strain rate in the zone of intense shear in which the chip is formed in machining from the dynamic flow stress properties of the work material and the cutting conditions
18. Minimum work as a possible criterion for determining the frictional conditions at the tool-chip interface in machining
19. On the stress distribution between the chip and tool during metal turning
20. Development of a predictive model for stress distributions at the tool-chip interface in machining
21. Predicting cutting forces in face milling