A new methodology for determining the stress state of the plastic region in machining with restricted contact tools

International Journal of Mechanical Sciences

Volumn 43, Issue 8, 2001, Pages 1747-1770

  Fang, N ^a   Jawahir, I S ^a  

^a UNIVERSITY OF KENTUCKY   (United States)

Author keywords

Comprehensive assessment; Maximum value principle; Restricted contact machining; Stress state of the plastic region; Universal slip line model

Indexed keywords

FRICTION; INTERFACES (MATERIALS); MATHEMATICAL MODELS; PLASTICITY; SHEAR STRESS; STRESS ANALYSIS;

RESTRICTED CONTACT MACHINING; UNIVERSAL SLIP-LINE MODELS;

MACHINE TOOLS;

EID: 0035427317     PISSN: 00207403     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0020-7403(01)00017-0     Document Type: Article

References (37)

1. Controlled contact cutting tools
2. Some controlled metal-cutting studies with resulfurized steels
3. The effect of tool-chip contact area in metal machining
4. Wear characteristics of carbide tools with artificially controlled tool-chip contact length
5. Free machining steel - IV: Tools with reduced contact length
6. Experiments with controlled contact tools
7. The effect of rake face configuration on the curvature of the chip in metal cutting
8. The operation and performance of a groove-type chip forming device
9. The tool restricted contact effect as a major influencing factor in chip breaking: An experimental analysis
10. Some slip-line fields for swaging or expanding indenting, extruding and machining for tools with curved dies
11. Slip-line fields in metal machining which involve centered fans
12. Some new slip-line solutions for two-dimensional steady-state machining
13. A slip-line field model for the determination of chip curl radius
14. Modeling chip formation with grooved tools
15. On the non-uniqueness of the machining process
16. A universal slip-line model with non-unique solutions for machining with curled chip formation and a restricted contact tool
17. The theory of plasticity applied to a problem of machining
18. Basic mechanics of the metal cutting process
19. A matrix technique constructing slip-line field solutions to a class of plane strain plasticity problems
20. A Fortran subroutine for solving systems of non-linear algebraic equations
21. On the limits set by plastic yielding to the intensity of singularities of stress
22. Flow stress model in metal cutting
23. Influence of strain, strain-rate and temperature on the flow stress in the primary deformation zone in metal cutting
24. The stress-state in the shear zone during steady state machining
25. Basic non-linearity in machining chatter
26. Numerical simulation of non-linear chatter vibration in turning
27. Three dimensional cutting force analysis in end milling
28. Prediction of specific cutting force and cutting force ratio in turning
29. Statistical analysis of cutting force ratios for flank-wear monitoring
30. A new performance-based criterion for optimum cutting condition and cutting tool selection in finish turning
31. The theory of plasticity applied to machining with cut-away tools
32. Some clarifications on the mechanics of chip formation when machining titanium alloys
33. Machining characteristics of hard materials
34. Chip formation with hard turning steel
35. Analytical predictions and experimental validation of cutting forces, chip thickness, and chip back-flow angle in restricted contact machining using the universal slip-line model