A new model for springback prediction in which the Bauschinger effect is considered

International Journal of Mechanical Sciences

Volumn 43, Issue 8, 2001, Pages 1813-1832

  Gau, Jenn Terng ^a   Kinzel, Gary L ^a  

^a Ohio State University   (United States)

Author keywords

Bauschinger effect; Cyclical loading; Mroz; Residual stress; Springback

Indexed keywords

BENDING (DEFORMATION); COMPUTER SIMULATION; CYCLIC LOADS; DEFORMATION; HARDENING; MATHEMATICAL MODELS; RESIDUAL STRESSES; SHEET METAL; STRAIN; STRESS ANALYSIS;

BAUSCHINGER EFFECT; MROZ MULTIPLE SURFACE MODEL; SPRINGBACK PREDICTION;

METAL FORMING;

EID: 0035427237     PISSN: 00207403     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0020-7403(01)00012-1     Document Type: Article

References (34)

1. The springback of metals
2. Discussion of Gardiner's paper
3. Elastic springback and residual stresses in sheet metal formed by bending
4. Springback after the biaxial elastic-plastic pure bending of rectangular plate - I
5. On the range of applicability of results for the springback of an elastic/perfectly plastic rectangular plate after subjecting it to biaxial pure bending - II
6. On springback after the pure bending of beams and plates of elastic work-hardening materials - III
7. On the range of applicability of results for the springback of an elastic/work-hardening rectangular plate after subjecting it to biaxial pure bending - IV
8. On analysis and measurement of residual stress in the bending of sheet metals
9. Influence of axial force on the elastic-plastic bending and springback of a beam
10. Bending of working-hardening metals under the influence of axial load
11. Elastic-plastic springback of sheet metals subjected to complex plane strain bending histories
12. The effect of restraining force on springback
13. Springback and residual stresses after stretch bending of working sheet metal
14. Mathematical modeling of plane-strain bending of sheet and plate
15. Development of a new model for plane strain bending and springback analysis
16. The Bauschinger effect and discontinuous yielding
17. A review of certain aspects of the Bauschinger effect in metals
18. Analysis of the Bauschinger effect
19. Springback in plane strain stretch/draw sheet forming
20. Springback analysis in orthotrpic sheet metal forming with an elasto plastic formulation using a kinematic hardening model
21. Elasto plastic formulation using a kinematic hardening model for springback analysis in sheet metal forming
22. Springback analysis of sheet metal subjected to bending-unbending under tension (Parts I and II)
23. Stress and residual stress distributions in plane strain bending
24. A hybrid membrane/shell method for rapid estimation of springback in anisotropic sheet metals
25. On the description of anisotropic work hardening
26. An attempt to describe the behavior of metal under cyclic loads using a more general workharding model
27. An anistropic hardening rule for the analysis of sheet metal forming operations
28. A modification of Prager's hardening rule
29. The Bauschinger effect in compression-tension of sheet metals