Trace Elements wDevelopment of In-vessel Type Control Rod Drive Mechanism for Marine Reactor Japan Ab Initio Calculations for the Substitutions of Al(OH) 4 and SO2-4 with Si Tetrahedra

Journal of Nuclear Science and Technology

Volumn 38, Issue 7, 2001, Pages 557-570

  Ishida, Toshihisa ^a   Imayoshi, Shou ^a   Yoritsune, Tsutomu ^a   Nunokawa, Hiroshi ^a   Aki Ochiai, Masa ^a   Ishizaka, Yuichi ^a,b  

^a JAPAN ATOMIC ENERGY AGENCY   (Japan)

^b Visiting Researcher in Japan Atomic Energy Research Institute ^*  (Japan)

Author keywords

Ball bearing operation; Control rod drive mechanism; Control rods; Electric motor driven type; High temperature water; In vessel type CRDM; Latch mechanism; Marine reactors

Indexed keywords

LATCHING; MAGNETOSTRICTIVE WIRE TYPE SENSOR; MARINE REACTOR;

BALL BEARINGS; CONTROL RODS; DURABILITY; ELECTRIC MOTORS; HIGH TEMPERATURE EFFECTS; MAGNETOSTRICTIVE DEVICES; NUCLEAR ENERGY; PERMANENT MAGNETS;

NUCLEAR REACTORS;

EID: 0035387468     PISSN: 00223131     EISSN: None     Source Type: Journal    
DOI: 10.1080/18811248.2001.9715067     Document Type: Article

References (11)

1. T. Kusunoki, et al, “Design of advanced integral-type marine reactor, MRX,” Nucl. Eng. Des., 201, 155-175 (2000).
2. Y. Wu, et al., “Hydraulic control rod drive system for 5MW nuclear heating reactor,” J. Tsinghua Univ., 30[6], 29 (1990).
3. H. Bo, et al, “Step dynamic process of the hydraulically-driven control rod, (I); Experiment of dynamic process bahavior,” J. Nucl. Sci. Technol., 37[12], 1032 (2000).
4. Y. Ishizaka, et al., “Development of a built-in type control rod drive mechanism (CRDM) for advanced marine reactor X (MRX),” Proc. ANP'92: Int. Conf. On Design and Safety of Advanced Nuclear Power Plants, Tokyo, p. 461-467 (1992).
5. D. V. Malyugin, “On the theory of Wiedeman effects,” J. Magn. Mater., 97, 193-197(1991).
6. W. Ervens, “Some properties of high-coercivity 2: 17 magnets,” Proc. 6th Int. Workshop on Rare-Earth Cobalt Magnets, Baden, p. 319-327(1982).
7. 17-type magnets for control rod drive mechanism (CRDM) in a nuclear reactor,” IEEE Trans. Magn, 31[6], p. 3653-3655 (1995).
8. I. Toshihisa, et al, “Tribological characteristics of rolling bearings in high-temperature (320°C), high-pressure (11.8 MPa) water,” Proc. Int. Tribology Conf., Nagasaki, Oct. 29-Nov. 2, 2000, (2000).
9. M. Nakamichi, et al, “Electrical properties on mineral insulated cables under nuetron irradiation,” Proc. 20th Symp. On Fusin Technology, Marseille, Sep., 1998, (1998).
10. S. Okuda, et al, “Effects of electron-beam and y ray irradiation on the magnetic flux of Nd-Fe-B and Sm-Co permanent magnets,” Nucl. Instrum. Methods Phys. Res., B94, 227-230 (1994).
11. J. R. Cost, et al., “Radiation effects in rare-earth permanent magnets,” Proc. Material Research Symp., Materials Research Soc., Vol. 96, (1987).