Damping of dynamic effects with elastomers in instrumented impact testing

International Journal of Fracture

Volumn 109, Issue 2, 2001, Pages 153-168

  Molnar S ^a   Bezeredi A ^a   Voros G ^a   Pukanszky B ^a  

^a BUDAPEST UNIVERSITY OF TECHNOLOGY AND ECONOMICS   (Hungary)

Author keywords

High rate fracture; Instrumented impact; LEFM; Mechanical damping; Silicone elastomers

Indexed keywords

DAMPING; DEFORMATION; FRACTURE MECHANICS; IMPACT TESTING; SILICONES; VISCOELASTICITY;

SILICON ELASTOMERS;

ELASTOMERS;

PLASTIC;

EID: 0035331287     PISSN: 03769429     EISSN: None     Source Type: Journal    
DOI: 10.1023/A:1011022016087     Document Type: Article

References (38)

1. Impact fracture toughness tests on polymers
2. Pitfalls in the evaluation of impact fracture of polymer-based materials
3. Mechanical damping effect of greases in instrumented impact testing
4. The design and evaluation of an instrumented impact tester
5. Mechanical damping in instrumented impact testing
6. The impact performance of thermoplastic sheet composites
7. The behaviour of notched bend specimens in impact testing
8. High-speed fracture mechanics by photography of polypropylene copolymers
9. Polypropylene composites: Fracture mechanics analysis of impact strength
10. Impact testing of polypropylene mouldings
11. The fracture mechanics of polymers at high rates
12. Fracture mechanics of polymers. Critical evaluation for linear elastic behaviour at high speed testing
13. Elastic impact loading of notched beams and bars
14. Instrumented impact testing
15. Analysis of the hopkinson pressure bar loaded instrumented charpy test using an inertial modeling technique
16. Dynamic fracture toughness measurement by instrumented impact bend testing and compact K testing
17. Instrumented impact testing of glass reinforced polypropylene
18. An impact fracture mechanics analysis of knit-lines in short fibre reinforced plastics
19. The influence of flow-induced anisotropy on the impact behaviour of injection-moulded short-fibre composites
20. Procedures and problems associated with reliable control of the instrumented impact test
21. Critical review of instrumented impact testing
22. Simple formula for dynamic stress intensity factor of pre-cracked charpy specimen
23. Fracture of ultrafine calcium carbonate/polypropylene composites
24. High-rate fracture toughness of polypropylene-based, hybrid, particulate composites
25. On the effects of higher vibration modes in the analysis of three point bend testing
26. Two degrees of freedom modeling of precracked beams under impact
27. Dynamic analysis of three point bend specimens under impact
28. The effect of contact condition on impact tests on plastics
29. An analysis of the forces and bending moments generated during the notched beam impact test
30. The determination of the fracture parameters for polymers in impact
31. Impact fracture characterization of plastics
32. Impact fracture of glass-flake reinforced polypropylene
33. The analysis of dynamic fracture using lumped mass-spring models
34. Instrumentation for impact testing of plastics