Cylindrical liquid jet grids for beam-port protection of thick-liquid heavy-ion fusion target chambers

Fusion Technology

Volumn 39, Issue 2, 2001, Pages 732-738

  Abbott, R ^a   Pemberton, S ^a   Peterson, P F ^a   Sun, G P ^b   Wright, P ^b   Holmes, R ^c   Latkowski, J ^c   Moir, R ^c   Springer, K ^c  

^a Etcheverry Hall MCI 730   (United States)

^b UNIVERSITY OF CALIFORNIA   (United States)

^c LAWRENCE LIVERMORE NATIONAL LABORATORY   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

FUSION REACTIONS; HEAVY IONS; JETS; NEUTRON BEAMS; NOZZLES; NUCLEAR ENERGY; RADIATION DAMAGE; TARGETS; TURBULENCE;

HEAVY ION FUSION CHAMBERS; NEUTRON COLLIMATION;

FUSION REACTORS;

EID: 0035270884     PISSN: 07481896     EISSN: None     Source Type: Journal    
DOI: 10.13182/fst01-a11963326     Document Type: Article

References (12)

1. Christofilos, N.C., A design for a high-power density ASTRON reactor, , UCID-15731
2. (See also J. Fusion Energy, Vol. 8, p. 97, 1989), Lawrence Livermore National Laboratory (1970).
3. Moir, R.W., et al., "HYLIFE-II: A Molten-Salt Inertial Fusion Energy Power Plant Design-Final Report, "Fusion Technology, 25, 5-25, (1994).
4. Peterson, P.F. "Design Methods for Thick-Liquid Protection of Inertial Fusion Chambers," Fusion Technology, this issue
5. Collins, J.A., M. Yoda, and S.I. Abdel-Khalik. "Direct Measurements of Free-Surface Smoothness in Turbulent Liquid Sheets," Fusion Technology, this issue.
6. Mehta, R.D. and P. Bradshaw, "Design Rules For Small Low-Speed Wind Tunnels," Aeronautical Journal, , 443-448, (1979).
7. Loehrke, R.I. and H.M. Nagib, "Control of Free-Stream Turbulence by Means of Honeycombs: A Balance Between Suppression and Generation," Journal of Fluids Engineering, 98, 342-353, (1976).
8. Peterson, P.F., IFE Target Chamber Design for Thick-Liquid Protection., UCB-NE-4228, Rev. A, Dept. of Nuclear Eng., University of California, Berkeley (2000).
9. Su, Y.-X., "Flow Analysis and Design of Three-Dimensional Wind Tunnel Contractions,"AIAA Journal, 29, 1912-1920, (1991).
10. McCarthy, M.J. and N.A. Molloy, "Review of Stability of Liquid Jets and the Influence of Nozzle Design, "The Chemical Engineering Journal, 7, 1-20, (1974).
11. Wu, P.K., R.F. Miranda, and G.M. Faeth, "Effects of Initial Flow Conditions on Primary Breakup of Nonturbulent and Turbulent Round Liquid Jets," Atomization and Sprays, 5, 175-196, (1995).
12. Zukauskas, A., "Heat transfer from tubes in crossflow," Adv. Heat Transfer, 8, 93, (1972).