Finite element analysis of tailor-welded blanks

Finite elements in analysis and design

Volumn 37, Issue 2, 2001, Pages 117-130

  Zhao, K M ^a,b   Chun, B K ^a   Lee, J K ^a  

^a OHIO STATE UNIVERSITY   (United States)

^b GENERAL MOTORS CORPORATION   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

COMPUTER SIMULATION; FINITE ELEMENT METHOD; HEAT AFFECTED ZONE; MATHEMATICAL MODELS; METAL FORMING; METAL STAMPING; SHEET METAL;

TAILOR-WELDED BLANKS;

WELDS;

EID: 0035252030     PISSN: 0168874X     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0168-874X(00)00026-3     Document Type: Article

References (6)

1. K.M. Radlmayr, J. Szinyur, IDDRG Working Groups Meeting, Associazione Italiana Di Metallurgia, 1-20121 MILANO, Piazzale Rodolfo Morandi, 2, Italy.
2. F.I. Saunders, Forming of tailor-welded blanks, Ph.D. Dissertation, Ohio State University, Columbus, OH, 1995.
3. A.A. Mustafa, D. Brouwers, L. Shulkin, et al., Deep drawing of round cups from tailor-welded blanks. J. Mater. Process. Technol. 53 (1995) 684-694.
4. K.M. Zhao, B.K. Chun, J.K. Lee, Numerical Modeling Technique for Tailor Welded Blanks, SAE Congress and Exposition, Detroit, 2000, Paper # 2000-01-0410.
5. K.M. Zhao, Cyclic stress-strain curve and springback simulation, Ph.D. Dissertation, The Ohio State University, Columbus, OH, 1999.
6. K.M. Zhao, J.K. Lee, On simulation of bending/reverse bending of sheet metals, Proceedings of International Mechanical Engineering Congress & Exposition, MED-10, Tennessee, USA, 1999, pp. 926-931.