Study of flow boiling heat transfer in a tube with axial microgrooves

Experimental Heat Transfer

Volumn 14, Issue 1, 2001, Pages 59-73

  Cheng, Lixin ^a   Chen, Tingkuan ^a  

^a EINDHOVEN UNIVERSITY OF TECHNOLOGY   (Netherlands)

Author keywords

[No Author keywords available]

Indexed keywords

AXIAL FLOW; BOILING LIQUIDS; HEAT TRANSFER COEFFICIENTS; MECHANICAL TESTING; PIPE FLOW; PRESSURE DROP; PRESSURE EFFECTS; TUBES (COMPONENTS);

AXIAL MICROGROOVES; FLOW BOILING HEAT TRANSFER; HEAT TRANSFER ENHANCEMENT; MASS FLUX;

HEAT TRANSFER;

EID: 0035240753     PISSN: 08916152     EISSN: None     Source Type: Journal    
DOI: 10.1080/089161501461648     Document Type: Article

References (23)

1. S. S. Hsieh and M. Y. Wen, An Experimental Study of Flow Boiling Heat Transfer in Rib-Roughened Tube Annuli, J. Heat Transfer, vol. 117, pp. 185-194, 1995.
2. A. E. Bergles, Heat Transfer Enhancement-The Encouragement and Accommodation of High Heat Fluxes, J. Heat Transfer, vol. 119, pp. 8-19, 1997.
3. A. E. Bergles, J. G. Collier, J. M. Dalhaye, G. F., Hewitt, and F. Mayinger, Two-Phase Flow and Heat Transfer in Power and Process Industries, Hemisphere, Washington, DC, 1981.
4. W. J. Yang and N. L. Zhang, in B. X. Wang (ed.), Transport Phenomena Science and Technology, pp. 1-5, Higher Education Press, Beijing, 1992.
5. D. B. Tuckermann and R. F. Pease, Optimized Convective Cooling Using Micromachined Structure, J. Electrochem. Soc., vol. 129, no. 3, p. C9, 1982.
6. D. B. Tuckermann and R. F. Pease, High-Performance Heat Sink for VLSI, IEEE Elect. Dev. Lett., vol. EDL-2, no. 5, pp. 126-129, 1991.
7. P. Y. Wu and W. A. Little, Measurement of Friction Factor for the Flow of Gases in Very Fine Channels Used for Microminiatyre Joule-Thompson Refrigerators, Cryogenics, vol. 23, pp. 273-277, 1983.
8. J. Pfathler, J. Harley, H. Bau, and J. Zemel, Liquid Transport in Micron and Sub-micron Channels, J. Sensors Actuators, vol. A21-23, pp. 431-434, 1990.
9. P. D. Dunn and D. A. Reay, Heat Pipes, Pergamon Press, New York, 1976.
10. L. X. Cheng, An Investigation on Performance of Enhanced Heat Transfer and Frictional Pressure Drop of Single and Two-Phase Flow in Internally Ribbed Tube and Tube with Microgrooves, Ph.D. thesis, Xi'an Jiaotong University, Xi'an, China, 1998.
11. S. J. Kline and F. A. McClintock, Describing Uncertainties on Single-Sample Experiments, Mech. Eng., vol. 57, pp. 3-8, 1953.
12. B. S. Petukhov, Heat Transfer and Friction in Turbulent Pipe Flow with Variable Physical Properties, Adv. Heat Transfer, vol. 6, pp. 503-564, 1970.
13. J. P. Holman, Heat Transfer, McGraw-Hill, New York, 1981.
14. J. G. Collier and J. R. Thome, Convective Boiling and Condensation, Oxford University Press, New York, 1994.
15. C. Corty and A. Foust, Surface Variables in Nucleating Boiling, Chem. Eng. Progr. Symp. Ser., vol. 51, no. 17, pp. 1-12, 1955.
16. S. G. Bankoff, Ebullition from Solid Surfaces in Absence of Pre-existing Gaseous Phase, Proc. Heat Transfer Fluid Mech. Inst., Stanford University, Stanford, CA, 1956.
17. S. G. Bankoff, Ebullition from Solid Surfaces in the Presence of a Pre-existing Gaseous Phase, Trans. ASME, vol. 79, p. 735, 1957.
18. S. G. Bankoff, Entrapment of Gas in the Spreading of a Liquid over a Rough Surface, AIChE J., vol. 4, no. 1, pp. 24-26, 1958.
19. H. B. Clark, P. H. Strengl, and J. W. Westwater, Active Sites for Nucleating Boiling, Chem. Eng. Progr. Symp. Ser., vol. 55, no. 29, pp. 103-110, 1959.
20. Y. Y. Hsu, On the Size Range of Active Nucleation Cavities on a Heating Surface, J. Heat Transfer, vol. 84, pp. 207-216, 1962.
21. Y. Y. Hsu and R. W. Graham, An Analytical and Experimental Study of the Thermal Boundary Layer and Ebullition Cycle in Nucleate Boiling, NASA Paper TND-594, 1961.
22. P. Griffith and J. D. Wallis, The Role of Surface Conditions in Nucleate Boiling, Chem. Eng. Progr. Symp. Ser., vol. 56, no. 49, pp. 49-63, 1960.
23. B. X. Wang, R. Liu, X. F. Peng, and G. M. Xiang, Research on Flow Boiling Heat Transfer on Surface with Microchannel, J. Eng. Thermophys., vol. 16, no. 3, pp. 321-326, 1995.