Modeling anisotropic strain hardening and deformation textures in low stacking fault energy fcc metals

International Journal of Plasticity

Volumn 17, Issue 6, 2001, Pages 837-860

  Kalidindi, Surya R ^a  

^a Drexel University   (United States)

Author keywords

A. Microstructures; A. Twinning; B. Crystal plasticity; B. Polycrystalline material; Brass texture

Indexed keywords

ANISOTROPY; BRASS; COPPER; CRYSTAL MICROSTRUCTURE; DEFORMATION; MATHEMATICAL MODELS; PLASTICITY; STACKING FAULTS; STRAIN; STRAIN HARDENING; STRESS ANALYSIS; TEXTURES; TWINNING;

CRYSTAL PLASTICITY;

POLYCRYSTALLINE MATERIALS;

EID: 0034744217     PISSN: 07496419     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0749-6419(00)00071-1     Document Type: Article

References (29)

1. Anand L., Kalidindi S.R. The process of shear band formation in plane strain compression of FCC metals. Effects of crystallographic texture Mechanics of Materials. 17:1994;223.
2. Asaro R.J., Needleman A. Texture development and strain hardening in rate dependent polycrystals. Acta Metall. 33:1985;923.
3. Asgari S., El-Danaf E., Kalidindi S.R., Doherty R.D. Strain hardening regimes and microstructural evolution during large strain compression of low stacking fault energy FCC alloys that form deformation twins. Met. Mater. Trans. 28A:1997;1781.
4. Bronkhorst C.A., Kalidindi S.R., Anand L. Polycrystalline plasticity and the evolution of crystallographic texture in FCC metals. Phil. Trans. R. Soc. Lond. A. 341:1992;443.
5. Duggan B.J., Hatherly M., Hutchinson W.B., Wakefield P.T. Deformation structures and textures in cold-rolled 70:30 brass. Mater. Sci. 12:1978;343.
6. El-Danaf E., Kalidindi S.R., Doherty R.D. Deformation texture transition in Brass. Critical role of micro-shear bands Acta Mater. 48:2000;2665.
7. El-Danaf, E., Kalidindi, S.R., Doherty, R.D., 2001. Influence of deformation path on the strain hardening behavior and microstructure evolution in low SFE FCC metals. Int. J. Plast., in press.
8. Gil Sevillano J., Van Houtte P., Aernoudt E. The contribution of macroscopic shear bands to the rolling texture of FCC Metals. Scripta Met. 11:1977;581.
9. Gurtin M.E. An Introduction to Continuum Mechanics. 1981;Academic Press, New York.
10. Heye W., Wasserman G. The formation of rolling textures of the face-centred cubic metals by means of slip, twinning, and development of limited fibre textures. II. Formation of rolling textures by means of slip and mechanical twinning (silver or alloy texture). Z. Metallkd. 59:1968;693.
11. Hirsch J., Lücke K., Hatherly M. Mechanism of deformation and development of rolling textures in polycrystalline F.C.C. metals - I. Description of rolling texture development in homogeneous CuZn alloys. Acta Metall. 36:1988;2863.
12. Hirsch J., Lücke K., Hatherly M. Mechanism of deformation and development of rolling textures in polycrystalline F.C.C. metals - III. The influence of slip inhomogeneities and twinning. Acta Metall. 36:1988;2905.
13. Kalidindi S.R. Incorporation of deformation twinning in crystal plasticity models. J. Mech. Phys. Solids. 46:1998;267.
14. Kalidindi S.R. Modeling the strain hardening response of low SFE FCC alloys. Int. J. Plast. 14:1998;1265.
15. Kalidindi S.R., Bronkhorst C.A., Anand L. Crystallographic texture evolution in bulk deformation processing of fcc metals. J. Mech. Phys. Solids. 40:1992;537.
16. Kocks U.F., Kallend J.S., Biondo A.C. Accurate representation of general textures by a set of weighted grains. Textures and Microstructures. 14-18:1991;199.
17. Leffers, T., 1968. RISO Report No. 184. RISO National Laboratory, Roskilde, Denmark.
18. Leffers, T., 1996. The brass-type texture once again. In: Proceedings of ICOTOM11, International Academic Publishers, vol. 1, p. 299.
19. Leffers, T. 1997. Microstructure - the forgotten factor in texture models. Proceedings of NASAT '97, Hyderabad, India.
20. Leffers T., Bilde-Sorensen J.B. Intra- and Intergranular heterogeneities in the plastic deformation of brass during rolling. Acta Metall. Mater. 38:1990;1917.
21. Leffers T., Grum-Jensen A. Development of rolling texture in copper and brass. Trans. Met. Soc. AIME. 242:1968;314.
22. Leffers, T., Kayworth, P. 1973. Twinning and texture. Proceedings of ICOTOM3, Paris, Societe Francaise de Metallurgie, p. 149.
23. Leffers T., Van Houtte P. Calculated and experimental orientation distributions of twin lamellae in rolled brass. Acta Metall. 37:1989;1191.
24. Smallman, R.E., 1955-1956. J. Inst. Metals 84, 10.
25. Smallman R.E., Green D. Acta Met. 12:1964;145-154.
26. Staroselsky A., Anand L. Inelastic deformation of F.C.C. materials by slip and twinning. J. Mech. Phys. Solids. 46:1998;671.
27. Taylor G.I. Plastic strain in metals. J. Inst. Metals. 62:1938;307.
28. Tome C.N., Lebensohn R.A., Kocks U.F. A model for texture development dominated by deformation twinning: Application to zirconium alloys. Acta Metall. Mater. 39:1991;2667.
29. Van Houtte P. Simulation of the rolling and shear texture of brass by the Taylor theory adapted for mechanical twinning. Acta Metall. 26:1978;591.