Influence of residual stress on the relationship between pipe pressure and C-ring tests

Polymer Engineering and Science

Volumn 40, Issue 11, 2000, Pages 2311-2316

  Whittle, A J ^a   Burford, R P ^b   Hoffman, M J ^b  

^a Iplex Pipelines   (Australia)

^b UNIVERSITY OF NEW SOUTH WALES   (Australia)

Author keywords

[No Author keywords available]

Indexed keywords

FAILURE ANALYSIS; MATERIALS TESTING; PLASTIC PIPE; RESIDUAL STRESSES; TENSILE STRESS; YIELD STRESS;

HOOP STRESSES; PRESSURE TESTS; VON MISES ANALYSIS;

POLYVINYL CHLORIDES;

EID: 0034317228     PISSN: 00323888     EISSN: None     Source Type: Journal    
DOI: 10.1002/pen.11363     Document Type: Article

References (13)

1. ASTM D 2837 Standard Test Method for Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials.
2. Australian New Zealand Standard AS/NZS 1462 Methods of Test of Plastics Pipes.
3. ASTM D 1598 Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure.
4. G. P. Marshall and W. M. Birch, The Rubber and Plastics Institute Plastics Pipes V, York (September 1982).
5. UK Water Industry Specification WRc Engineering Information and Guidance Note No. 4-31-04 (February 1986).
6. G. P. Marshall, E. Ingham, and S. Brogden, The Institute of Materials. Plastics Pipes IX, Edinburgh (September 1995).
7. J. G. Williams and J. M. Hodgkinson, Polym. Eng. Sci., 21, 822 (1981).
8. E. Q. Clutton and J. G. Williams, Polym. Eng. Sci., 38, 1381 (1995).
9. UK Water Industry Specification, WRC Engineering, Information and Guidance Note No. 4-32-03 (May 1987).
10. I. Bjorklund, Europipe '83, Basie, Switzerland, Paper 7, 47 (1983).
11. J. G. Williams, Stress Analysis of Polymers, p. 178, Ellis Horwood Limited, Chichester, U.K. (1980).
12. A. W. Birley, B. Haworth, and J. Batchelor, Physics of Plastics, Hanser Publishers, Munich (1992).
13. International Standard ISO 9967 Thermoplastics Pipes - Determination of Creep Ratio.