Sol-gel preparation of scratch-resistant Al2O3 coatings on float glass

Glass Science and Technology: Glastechnische Berichte

Volumn 72, Issue 12, 1999, Pages 386-392

  Hauk, Rainer ^a,c   Frischat, Günther Heinz ^a   Ruppert, Karl ^b  

^a CLAUSTHAL UNIVERSITY OF TECHNOLOGY   (Germany)

^b BMW AG   (Germany)

^c VGT Dyko Industriekeramik V   (Germany)

Author keywords

[No Author keywords available]

Indexed keywords

CORUNDUM; DISPERSIONS; ETCHING; PROTECTIVE COATINGS; QUARTZ; SOL-GELS;

ALUMINUM BUTOXIDE; BOEHMITE; FLOAT GLASS; SCRATCH RESISTANCE;

GLASS;

EID: 0033347262     PISSN: 09467475     EISSN: None     Source Type: Journal    
DOI: None     Document Type: Article

References (27)

1. Holtmann, K. H.; Frischat, G. H.; Ruppert, K.: Mechanism of defect creation on sheet glass by particle impact and its influence on stray light. Glastech. Ber. Glass Sci. Technol. 71 (1998) no. 8, p. 247-255.
2. Nölle, G.: Technik der Glasherstellung. 3rd ed. Stuttgart: Deutscher Verlag für Grundstoffindustrie, 1997.
3. Tanaka, K.: Elastic/plastic indentation hardness and indentation fracture toughness: inclusion cure model. J. Mat. Sci. 22 (1987) p. 1501-1508.
4. Lawn, B. R.; Fuller, E. R.; Wiederhorn S. M.: Strength degregation of brittle surfaces: Sharp indentors. J. Am. Ceram. Soc. 59 (1976) no. 5-6, p. 193-197.
5. Chiang, S. S.; Marshall, D. B.; Evans, A. G.: The response of solids to elastic/plastic indentation, stresses and residual stresses. J. Appl. Phys. 53 (1982) p. 298-311.
6. Cook, R. F.; Pharr, G. M.: Direct observation and analysis of indentation cracking in glass and ceramics. J. Am. Ceram. Soc. 73 (1990) no. 4, p. 787-817.
7. Beer, U.: Vergleich der Kratzfestigkeit verschiedener Einscheibensicherheitsgläser mit nicht vorgespannten Floatgläsern. Institut für Nichtmetallische Werkstoffe, Tech. Univ. Clausthal, Studienarbeit 1996.
8. Conway, J. C.; Kirchner, H. P.: The mechanics of crack initation and propagation beneath a moving sharp indentor. J. Mat. Sci. 15 (1980) p. 2879-2883.
9. Cheng, W.; Finnie, I.: A prediction on the strength of glass following the formation of subsurface flows by scribing. J. Am. Ceram. Soc. 75 (1992) no. 9, p. 2565-2572.
10. Dannheim, H.; Oel, H. J.; Prechtl, W.: Einfluß der Vorspannung auf die Oberflächendefektentstehung bei thermisch vorgespannten Flachgläscrn. Glastechn. Ber. 54 (1981) no. 10, p. 312-318.
11. Burnett, P. J.; Rickerby, D. S.: The scratch adhesion test: An elastic-plastic indentation analysis. Thin Solid Films 157 (1988) p. 233-254.
12. Etienne, P.; Denape, J.; Paris, J. Y. et al.: Tribological properties of ormosil coatings. J. Sol - Gel Sci. Technol. 6 (1996) p. 287-297.
13. Hlaváč, J.: The technology of glass and ceramics. An introduction. Glass science and technology 4. Amsterdam et al.: Elsevier 1983.
14. Petzold, A.; Ulbricht, J.: Aluminiumoxid - Rohstoff, Werkstoff, Werkstoffkomponente, Leipzig: Deutscher Verlag für Grundstoffindustrie, 1990.
15. 3-seeded boehmite-derived alumina. J. Am. Ceram. Soc. 76 (1993) no. 1, p. 214-222.
16. 3-gels. In: Hench, L. L.; Ulrich, D. R. (eds.): Ultrastructure processing of ceramics, glasses and composites. Proc. Int. Conf. Gainsville, FL, 1983. New York: Wiley, 1984. p. 142-151.
17. McArdle, J. L.; Messing, G. L.: Seeding with γ-alumina for transformation and microstructure control in boehmite-derived α-alumina. J. Am. Ceram. Soc. 69 (1986) no. 5, p. C-98-C-101.
18. Kumagai, M.; Messing, G. L.: Controlled transformation and sintering of a boehmite sol-gel by α-alumina seeding. J. Am. Ceram. Soc. 68 (1985) no. 9, p. 500-505.
19. Messing, G. L.; Kumagai, M.; Shelleman, R. A. et al.: Seeded transformations for microstructural control in ceramics. In: Hench, L. L.; Ulrich, D. R. (eds.): Science of ceramic chemical processing. New York et al.: Wiley, 1986. p. 259-271.
20. 3-Schichten nach dem Sol-Gel-Verfahren. Diss., Tech. Univ. Clausthal, 1997.
21. Brinker, C. J.; Scherer, G. W.: Sol-gel science: The physics and chemistry of sol gel processing. San Diego et al.: Academic Press, 1990.
22. Beier, W.; Glasbildung und Glasstruktur unter besonderer Berücksichtigung des Alkoxid-Gel-Verfahrens. Tech. Univ. Clausthal, habil. thesis 1989.
23. Iler, R. K.: Inorganic colloids for forming ultrastructures. In: Hench, L. L.; Ulrich, D. R. (eds.): Science of ceramic chemical processing. New York et al.: Wiley, 1986. p. 3-20.
24. Scherer, G. W.: Glasses and ceramics from colloids. J. Non-Cryst. Solids 73 (1985) p. 661-667.
25. Johnson, D. W. Jr.: Sol-gel processing of ceramic and glass. Am. Ceram. Soc. Bull. 64 (1985) no. 12, p. 1597-1602.
26. Schafer, M. W.: The chemistry of and physics with porous sol-gel glasses. J. Appl. Phys. 61 (1987) p. 5438-5446.
27. Rädlein, E.; Ambos, R.; Frischat, G. H.: Atomic force microscopy of coated glasses. Fresenius J. Anal. Chem. 353 (1995) p. 413-418.