Structural response of LVR flexible pavements at Mn/road project

Journal of Transportation Engineering

Volumn 125, Issue 3, 1999, Pages 238-244

  Garg, Navneet ^a   Thompson, Marshall R ^a  

^a UNIVERSITY OF ILLINOIS AT URBANA CHAMPAIGN   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

EID: 0033121569     PISSN: 0733947X     EISSN: None     Source Type: Journal    
DOI: 10.1061/(ASCE)0733-947X(1999)125:3(238)     Document Type: Article

References (11)

1. Elliott, R. P., and Thompson, M. R. (1985). "Mechanistic design concepts for conventional flexible pavements." Transp. Engrg. Ser. No. 42, Civil Engineering Studies, University of Illinois at Urbana-Champaign, Urbana, Ill.
2. Freund, R. J., and Wilson, W. J. (1993). Statistical methods. Academic, Harcourt Brace Jovanovich, San Diego.
3. Garg, N. (1997). "Mechanistic-empirical evaluation of Mn/ROAD low volume road test sections," PhD thesis, Department of Civil Engineering, University of Illinois at Urbana-Champaign, Urbana, Ill.
4. Garg, N., and Thompson, M. R. (1997). "Laboratory characterization of Mn/ROAD granular materials." Transp. Res. Rec. 1577, Transportation Research Board, Washington, D.C.
5. Hill, H. J. (1988). "Early life study of the FA 409 full-depth asphalt concrete pavement sections," PhD thesis, Department of Civil Engineering, University of Illinois at Urbana-Champaign, Urbana, Ill.
6. Maser, K. R. (1994). "Ground penetrating radar survey of pavement thickness on Mn/ROAD sections." Rep., Minnesota Department of Transportation, Infrasense Inc., Cambridge, Mass.
7. "Research and development of the Asphalt Institute's thickness design manual (MS-1), ninth edition." (1982). Res. Rep. No. 82-2, The Asphalt Institute.
8. Stroup-Gardiner, M., and Newcomb, D. E. (1997). "Investigation of hot mix asphalt mixtures at Mn/ROAD." Rep. No. 97-06, Center for Transportation Studies, University of Minnesota, Minneapolis, Minn.
9. Stubstad, R. N., Baltzer, S., Lukanen, E. O., and Ertman-Larsen, H. J. (1994). "Prediction of AC mat temperatures for routine load/deflection measurements." Proc., 4th Int. Conf. on Bearing Capacity of Roads and Airfields, Minneapolis, Minn.
10. Thompson, M. R. (1989). "ILLI-PAVE based NDT analysis procedures." ASTM Int. Symp. on Non-Destructive Testing of Pavement Struct., ASTM Annu. Meeting, ASTM STP 1026, ASTM, West Conshohocken, Pa.
11. Thompson, M. R. (1994). "ILLI-PAVE based thickness design concepts and practices for surface treatment pavements." Proc., 4th Int. Conf. on Bearing Capacity of Roads and Airfields, Minneapolis, Minn.