Analysis of the dynamics of heat transfer between a hot wire probe and gas fluidized beds

Powder Technology

Volumn 102, Issue 1, 1999, Pages 53-63

  Boerefijn, R ^a   Poletto, M ^b   Salatino, P ^a  

^a UNIVERSITY OF NAPLES FEDERICO II   (Italy)

^b UNIVERSITY OF SALERNO   (Italy)

Author keywords

Dynamics; Fluidized bed; Heat transfer; Hot wire anemometer

Indexed keywords

ANEMOMETERS; FLUIDIZATION; FLUIDIZED BEDS; GLASS; HEAT TRANSFER COEFFICIENTS; MATHEMATICAL MODELS; PARTICLE SIZE ANALYSIS; POWDERS; PROBABILITY DISTRIBUTIONS; SILICA;

HEAT TRANSFER RATE; HOT WIRE ANEMOMETRY;

HEAT TRANSFER;

GLASS; POLYCARBONATE; SILICON DIOXIDE; STAINLESS STEEL;

FLUIDIZED BED; HEAT TRANSFER; HOT WIRE PROBE;

ANEMOMETRY; ARTICLE; FLUIDIZED BED; GAS; HEAT TRANSFER; MATHEMATICAL MODEL; PARTICLE SIZE; SOLID; THERMODYNAMICS;

EID: 0033047152     PISSN: 00325910     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0032-5910(98)00186-7     Document Type: Article

References (24)

1. Geldart D. Types of gas fluidization. Powder Technol. 7:1973;285-292.
2. Molerus O. Heat transfer in gas fluidized beds - Part 1. Powder Technol. 70:1992;1-14.
3. Martin H. Fluid-bed heat exchangers - a new model for particle convective energy transfer. Chem. Eng. Commun. 13:1981;1-16. (ASME-paper 80-HT-60).
4. Botterill J.S.M. Comments on the paper 'Fluid bed heat exchangers - a new model for particle convective heat transfer' by H. Martin. Chem. Eng. Commun. 13:1981;17-19.
5. Phillips M.C. A parametric study on the relative importance of packet formation and single-particle motion in fluidized bed heat transfer. Chem. Eng. Sci. 45(8):1990;2195-2202.
6. Mickley H.S., Fairbanks D.F. Mechanism of heat transfer to fluidized beds. AIChE J. 1(3):1955;374-384.
7. Koppel L.B., Patel R.D., Holmes J.T. Statistical models for surface renewal in heat and mass transfer: Part I. Dependence of average transport coefficients on age distribution. AIChE J. 12:1966;941-946.
8. Koppel L.B., Patel R.D., Holmes J.T. Statistical models for surface renewal in heat and mass transfer: Part II. Techniques for measurement of age distribution at transport surfaces. AIChE J. 12:1966;947-955.
9. Koppel L.B., Patel R.D., Holmes J.T. Statistical models for surface renewal in heat and mass transfer: Part III. Residence times and age distributions at wall surface of a fluidized bed, application of spectral density. AIChE J. 16:1970;456-464.
10. Koppel L.B., Patel R.D., Holmes J.T. Statistical models for surface renewal in heat and mass transfer: Part IV. Wall to fluidized bed heat transfer coefficients. AIChE J. 16:1970;464-471.
11. Marsheck R.M., Gomezplata A. Particle flow patterns in a fluidized bed. AIChE J. 11:1965;167-173.
12. M. Baerns, Fluidization of fine particles, in: A.A.H. Drinkenburg (Ed.), Fluidization, Netherlands Univ. Press, Amsterdam, NL, 1967, pp. 403-415.
13. C.Y. Wen, R. Krishnan, R. Khosravy, S. Dutta, Dead zone heights near the grid of fluidized beds, in: J.F. Davidson, D.L. Keairns (Eds.), Fluidization, Cambridge Univ. Press, Cambridge, UK, 1978, pp. 32-37.
14. Osberg G.L. Locating fluidized solids bed level in a reactor. Hot wire method. Ind. Eng. Chem. 43:1951;1871-1873.
15. Jacob A., Osberg G.L. Effect of gas thermal conductivity on local heat transfer in a fluidised bed. Can. J. Chem. Eng. 35:1957;5-9.
16. Turton R., Colakyan M., Levenspiel O. Heat transfer from fluidized beds to immersed wires. Powder Technol. 53:1987;195-203.
17. Macias-Machin A., Oufer L., Wannenmacher N. Heat transfer between an immersed wire and a liquid fluidised bed. Powder Technol. 66:1991;281-284.
18. R. Boerefijn, M. Poletto, P. Salatino, A study of the dynamic behaviour of fluidized beds based on a hot wire anemometry technique, in: J.-F. Large, M. Bergougnou (Eds.), Fluidization VIII, Engineering Foundation, New York, 1996, pp. 21-30.
19. Richardson J.F., Zaki W.N. Sedimentation and fluidization: Part I. Trans. Inst. Chem. Eng. 32:1954;35-53.
20. Raso G. Sonde a dissipazione di calore. Quaderni dell'Ing. Chim. Ital. 11-12:1975;181-189. Suppl. of La Chimica e l'Industria.
21. L.R. Glicksman, N.A. Decker, Design relationships for predicting heat transfer to tube bundles in fluidised bed combustors, Proc. 6th Int. Conf. Fluidised Bed Combustion, Atlanta, 3, 1980, pp. 1152-1157.
22. Schlünder E.U. Heat transfer to moving spherical packings at short contact times. Int. Chem. Eng. 20:1980;550-553.
23. Massimilla L., Donsi G., Zucchini C. The structure of bubble-free fluidized beds of fine fluid cracking catalyst. Chem. Eng. Sci. 27:1972;2005-2015.
24. Slis P.L., Willemse T.W., Kramers H. The response of the level of a liquid fluidized bed to a sudden change in the fluidizing velocity. Appl. Sci. Res. A. 8:1959;209-218.