Energy input of a centrifugal stage into the attached piping system during mild surge

Journal of Engineering for Gas Turbines and Power

Volumn 121, Issue 2, 1999, Pages 325-334

  Ribi, B ^a,b   Gyarmathy, G ^a  

^a ETH ZURICH   (Switzerland)

^b Sulzer Ltd   (Switzerland)

Author keywords

[No Author keywords available]

Indexed keywords

DIFFUSERS (FLUID); FLOW OF FLUIDS; MATHEMATICAL MODELS; OSCILLATIONS; PIPELINES; POTENTIAL ENERGY; PRESSURE EFFECTS; STABILITY; SURGES (FLUID);

CENTRIFUGAL COMPRESSOR STAGE; DYNAMIC INSTABILITY; ENERGY INPUT; QUASI STEADY CHARACTERISTIC;

COMPRESSORS;

EID: 0032681639     PISSN: 07424795     EISSN: 15288919     Source Type: Journal    
DOI: 10.1115/1.2817124     Document Type: Article

References (19)

1. Abdel-Hamid, A. N., 1985, “Dynamic Response of a Centrifugal Blower to Periodic Flow Fluctuations,” ASME Paper No, 85-GT-195.
2. Bons, J. P., 1994, “Dynamic Surge Behavior of a Centrifugal Pumping System,” ASME Paper No. 94-GT-150.
3. Clements, W. W. and Artt, D. W., 1987, “The Influence of Diffuser Channel Geometry on the Flow Range and Efficiency of a Centrifugal Compressor,” Proceedings, Inst. IMechE, Vol. 201 No. A2 (C41/8).
4. Bloch, G. S. and O’Brien, W. F., 1992, “A Wide-Range Axial-Flow Compressor Stage Performance Model,” ASME Paper No. 92-GT-58.
5. Davies, M. W. Jr., Owen, A. K., O’Brien, W. F., and Cousins, W. T., 1995, “Joint Dynamic Airbreathing Propulsion Simulations Partnerships (JDAPS),” ASME Paper No. 95-GT-279.
6. Fink, D. A., Cumpsty, N. A., and Greitzer, E. M., 1991, “Surge Dynamics in a Free-Spool Centrifugal Compressor System,” ASME Paper No. 91-GT-31.
7. Greitzer, E. M., 1975, “Surge and Rotating Stall in Axial Flow Compressors: Part l-Theoretical Compression System Model,” ASME Paper No. 75-GT-9.
8. Greitzer, E. M., 1981, “The Stability of Pumping Systems-The Freeman Scholar Lecture,” ASME Journal of Fluids Engineering, Vol. 103, pp. 193-242.
9. Hansen, K. E., J0rgensen, P., and Larsen, P. S., 1981, “Experimental and Theoretical Study of Surge in a Small Centrifugal Compressor,” ASME Journal of Fluids Engineering, Vol. 103, pp. 391-395.
10. Hunziker, R., and Gyarmathy, G., 1993, “The Operational Stability of a Centrifugal Compressor and its Dependence on the Characteristics of the Subcomponents,” ASME Paper No. 93-GT-284.
11. Hunziker, R., 1993, “Einfluss der Diffusorgeometrie auf die Instabilitätsgrenze des Radialverdichters,” Thesis, ETH Nr. 10252, ETH Zürich.
12. Japikse, D., 1987, “The Technology of Centrifugal Compressors: A Design Approach and New Goals for Research,” lecture notes on the flow in centrifugal compressors, Von Karman Institute, Brussels.
13. Kenny, D. P., 1972, “Lectures on the radial compressor,” Von Karman Institute, Brussels.
14. Löhle, M., 1986, “Experimentelle und theoretische Untersuchung des dynamischen Betriebsverhaltens eines dreistufigen Radialverdichters,” Thesis, Universität Stuttgart, Germany.
15. Ribi, B., and Gyarmathy, G., 1993, “Impeller Rotating Stall as a Trigger for the Transition from Mild to Deep Surge in a Subsonic Centrifugal Compressor,” ASME Paper No. 93-GT-234.
16. Ribi, B., and Gyarmathy, G., 1995, “The Behavior of a Centrifugal Compressor Stage during Mild Surge,” paper presented at the lrst European Conf. Turbomachinery-Fluid Dynamic and Thermodynamic Aspects, VDI Berichte Nr. 1186.
17. Simon, J. S., Valavani, L., Epstein, A. H., and Greitzer, E. M., 1992, “Evaluation of Approaches to Active Compressor Surge Stabilization,” ASME Paper No. 92-GT-182.
18. Stein, W., 1986, “Beitrag zur Analyze der gegenseitigen Beeinflussung von Laufrad und Diffusorbeschaufelung in Radialverdichtern,” Thesis, Hannover.
19. Verdonk, G., 1978, “Theoretical and Experimental Investigation of the Flow at the Inlet of the Vaned Diffuser for a High Pressure Ratio Centrifugal Compressor,” Technical Note 125, Von Karman Institute, Brussels.