Experimental study of post-build cure of stereolithography polymers for injection molds

Rapid Prototyping Journal

Volumn 5, Issue 2, 1999, Pages 72-81

  Colton, Jonathan ^a   Blair, Bryan ^a,b  

^a GEORGIA INSTITUTE OF TECHNOLOGY   (United States)

^b LEXMARK INTERNATIONAL INC   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

CURING; EPOXY RESINS; INJECTION MOLDING; LITHOGRAPHY; OVENS;

STEREOLITHOGRAPHY;

RAPID PROTOTYPING;

EID: 0032668196     PISSN: 13552546     EISSN: None     Source Type: Journal    
DOI: 10.1108/13552549910267452     Document Type: Article

References (8)

1. American Society for Testing and Materials (1991), ASTM 2240 D-91, "Standard test method for rubber property - durometer hardness," Philadelphia, PA.
2. Blair, B. (1998), "Post-build processing of stereolithography molds", Master's Thesis, School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, Georgia, May.
3. Ciba Geigy (1994), Cibatool, Resin Data Supplement, P/N 19140-S10-00 Rev A, Ciba Geigy, East Lansing, MI.
4. Dawson, K. (1997), Unpublished Data, Rapid Prototyping and Manufacturing Institute at the Georgia Institute of Technology, Atlanta, Georgia.
5. Du Pont (1997), Somos® 7100 Resin Data Sheet, Du Pont, New Castle, DE.
6. Jacobs, P. (1996), Stereolithography and Other RP&M Technologies: From Rapid Prototyping to Rapid Tooling, Society of Manufacturing Engineers, Dearborn, MI.
7. Jayanthi, S., Hokuf, B. and Lawton, J. (1995), "Influence of post-curing conditions on the mechanical properties of stereolithographic photopolymers," Du Pont Somos Materials Group, August.
8. Rahmati, S. and Dickens, P. (1997), "Stereolithography injection mould tool failure analysis," Department of Manufacturing Engineering and Operations Management, University of Nottingham.