Investigation of adiabatic wall film effectiveness of inclined multihole wall film cooling with different deflected angle

Tuijin Jishu/Journal of Propulsion Technology

Volumn 19, Issue 5, 1998, Pages 43-46

  Lin, Yuzhen ^a   Song, Bo ^a   Li, Bin ^a   Liu, Gaoen ^a  

^a BEIHANG UNIVERSITY   (China)

Author keywords

Adiabatic wall film effectiveness+; Film cooling; Gas turbine engine; Porous wall

Indexed keywords

COMBUSTORS; COOLING; HEAT TRANSFER; MASS TRANSFER; POROUS MATERIALS;

ADIABATIC WALL FILM EFFECTIVENESS; FILM COOLING;

GAS TURBINES;

EID: 0032256069     PISSN: 10014055     EISSN: None     Source Type: Journal    
DOI: None     Document Type: Article

References (9)

1. Mayle R E, Camarata F J. Multihole cooling film effectiveness and heat transfer. Trans of ASME, Journal of Heat Transfer, 1975, 97
2. Sasaki M, Takahara K, Kumagai T. Film cooling effectiveness for injection from multirow holes. ASME Parper 78-GT-32, 1978.
3. Crawford M E, Kays W M, Moffat R J. Full-coverage film cooling part I: comparison of heat transfer data for three injection angles. ASME Paper 80-GT-43, 1980.
4. Kumada M, Kasagi N, Hirata M. Studies of full-coverage film cooling part 2: measurement of local heat transfer coefficient. ASME Paper 81-GT-38, 1981.
5. Pedersen D R, Eckert E R G, Goldstein R J. Film cooling with large density difference between the main stream and secondary fluid measured by the heat-mass transfer analogy. Trans of the ASME, Journal of Heat Transfer 1977, 99: 620-627