Active Stabilization of Rotating Stall and Surge in a Transonic Single-Stage Axial Compressor

Journal of Turbomachinery

Volumn 120, Issue 4, 1998, Pages 625-636

  Weigl, H J ^a   Paduano, J D ^a   Frechette, L G ^a   Epstein, A H ^a   Greitzer, E M ^a   Bright, M M ^b   Strazisar, A J ^b  

^a Massachusetts Institute of Technology Cambridge   (United States)

^b NASA GLENN RESEARCH CENTER   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

AXIAL FLOW TURBOMACHINERY; DAMPING; FEEDBACK CONTROL; ROTATIONAL FLOW; STABILITY; SURGES (FLUID); TRANSONIC FLOW;

MACH NUMBER; ROTATING STALL; TRANSONIC SINGLE-STAGE AXIAL COMPRESSORS;

COMPRESSORS;

AXIAL COMPRESSOR; STABILITY; STALL; SURGE; TRANSONIC FLOW;

EID: 0032194592     PISSN: 0889504X     EISSN: 15288900     Source Type: Journal    
DOI: 10.1115/1.2841772     Document Type: Article

References (29)

1. Behnken, R. L., D’Andrea, R., and Murray, R. M., 1995, “Control of Rotating Stall in a Low-Speed Axial Flow Compressor Using Pulsed Air Injection: Modeling, Simulations, and Experimental Validation,” presented at the 34th IEEE Conference on Decision and Control, New Orleans, Dec. 13-15.
2. Berndt, R. G., 1995, “Actuation for Rotating Stall Control of High Speed Axial Compressors,” M. S. Thesis, MIT Department of Aeronautics and Astronautics.
3. Berndt, R. G., Weigl, H. J., Paduano, J. D., and Epstein, A. H., 1995, “Experimental Techniques for Actuation, Sensing, and Measurement of Rotating Stall Dynamics in High-Speed Compressors,” presented at the SPIE International Symposium on Aerospace/Defense Sensing and Dual-Use Photonics, Apr. 17-18, Orlando, FL.
4. Bonnaure, L. P., 1991, “Modeling High Speed Multistage Compressor Stability,” M.S. Thesis, MIT Department of Aeronautics and Astronautics.
5. Day, I. J., 1993, “Active Suppression of Rotating Stall and Surge in Axial Compressors,” ASME Journal of Turbomachinery, Vol. 115, pp. 40-47.
6. Epstein, A. H., Ffowcs-Williams, J. E., and Greitzer, E. M., 1989, “Active Suppression of Aerodynamic Instabilities in Turbomachines,” Journal of Propulsion, Vol. 5, No. 2, pp. 204-211.
7. Eveker, K. M., Gysling, D. L., Nett, C. N., and Sharma, O. P., 1995, “Integrated Control of Rotating Stall and Surge in a Low-Speed Axial Compression System,” presented at the SPIE International Symposium on Aerospace/Defense Sensing and Dual-Use Photonics, Apr. 17-18, Orlando, FL.
8. Fréchette, L. G., 1997, “Implications of Stability Modeling for High-Speed Axial Compressor Design,” M. S. Thesis, MIT Department of Aeronautics and Astronautics.
9. Feulner, M. R., Hendricks, G. J., and Paduano, J. D., 1996, “Modeling for Control of Rotating Stall in High Speed Multi-Stage Axial Compressors,” ASME Journal of Turbomachinery, Vol. 118, pp. 1-10.
10. Gysling, D. L., and Greitzer, E. M., 1994, “Dynamic Control of Rotating Stall in Axial Flow Compressors Using Aeromechanical Feedback,” ASME Paper No. 94-GT-292.
11. Haynes, J. M., Hendricks, G. J., and Epstein, A. H., 1994, “Active Stabilization of Rotating Stall in a Three-Stage Axial Compressor,” ASME Journal ofTurbo-machinery, Vol. 116, pp. 226-239.
12. Hendricks, G. J., Bonnaure, L. P., Longley, J. P., Greitzer E. M., and Epstein A. H., 1993, “Analysis of Rotating Stall Onset in High-Speed Axial Flow Compressors,” AIAA Paper No. 93-2233.
13. Hendricks, G. J., and Gysling, D. L., 1994, “A Theoretical Study of Sensor-Actuator Schemes for Rotating Stall Control,” Journal of Propulsion and Power, Vol. 10, No. 1.
14. Hendricks, G. J., Sabnis, J. S., and Feulner, M. R., 1997, “Analysis of Instability Inception in High-Speed Multi-Stage Axial-Flow Compressors,” ASME Journal of Turbomachinery, Vol. 119, pp. 714-722.
15. Koch, C. C., and Smith, L. H„ 1968, “Experimental Evaluation of Outer Case Blowing or Bleeding of Single Stage Axial Flow Compressor. Part III—Performance of Blowing Insert Configuration No. 1,” NASA CR-54589, GE R68AEG318.
16. Koch, C. C., 1970, “Experimental Evaluation of Outer Case Blowing or Bleeding of Single Stage Axial Flow Compressor. Part IV-Final Report,” NASA CR-54592, GE R69AEG256.
17. Kwakernaak, H., 1993, “Robust Control and Hinf-Optimization—Tutorial Paper,” Automatica, Vol. 29, No. 2, pp. 255-273.
18. Longley, J. P., 1994, “A Review of Non-steady Flow Models for Compressor Stability,” ASME Journal of Turbomachinery, Vol. 116, pp. 202-215.
19. Moore, F. K., and Greitzer, E. M., 1986, “A Theory of Post-Stall Transients in Axial Compression Systems, Part I—Development of Equations; Part II— Application,” ASME Journal of Engineering for Gas Turbines and Power, Vol. 108, pp. 68-97.
20. Paduano, J. D., Epstein, A. H., Valavani, L., Longley, J. P., Greitzer, E. M., and Guenette, G. R., 1993, “Active Control of Rotating Stall in a Low-Speed Axial Compressor,” ASME Journal of Turbomachinery, Vol. 115, pp. 4856.
21. Paduano, J. D., Valavani, L., Epstein, A. H., and Greitzer, E. M., 1994, “Modeling for Control of Rotating Stall,” Automatica, Vol. 30, No. 9, Sept.
22. Reid, L., and Moore, R. D., 1978a, “Design and Overall Performance of Four Highly Loaded, High Speed Inlet Stages for an Advanced High Pressure Ratio Core Compressor,” NASA TP-1337.
23. Reid, L., and Moore, R. D., 1978b, “Performance of Single-Stage Axial-Flow Transonic Compressor With Rotor and Stator Aspect Ratios of 1.19 and 1.26, Respectively, and With Design Pressure Ratio of 1.82,” NASA TP-1338.
24. Setiawan, J. D., 1996, “Distortion Tolerance of Stall/Surge Controllers in Axial Compression Systems,” M. S. Thesis, MIT Department of Aeronautics and Astronautics.
25. Smith, R. S., Chu, C., Fanson, J. L., 1994, “The Design of Controllers for an Experimental Non-collocated Flexible Structure Problem,” IEEE Trans, on Control Systems Technology, Vol. 2, No. 2, pp. 101-109.
26. Smith, R. S., 1995, “Technical Notes and Correspondence: Eigenvalue Perturbation Models for Robust Control,” IEEE Trans, on Automatic Control, Vol. 40, No. 6, pp. 1063-1066.
27. Tryfonidis, M., Etchevers, O., Paduano, J. D., Epstein, A. H., and Hendricks, G. J., 1995, “Pre-stall Behavior of Several High-Speed Compressors,” ASME Journal of Turbomachinery, Vol. 117, pp. 62-80.
28. Vo, H. D., 1997, “Active Control of Rotating Stall in a Three-Stage Axial Compressor With Jet Actuators,” M.S. Thesis, MIT Department of Aeronautics and Astronautics.
29. Weigl, H. J., 1997, “Active Stabilization of Rotating Stall and Surge in a Transonic Single Stage Axial Compressor,” Ph.D. Thesis, MIT Department of Aeronautics and Astronautics.