Identification of the machine settings of real hypoid gear tooth surfaces

Journal of Mechanical Design, Transactions of the ASME

Volumn 120, Issue 3, 1998, Pages 429-440

  Gosselin, C ^a   Nonaka, T ^b   Shiono, Y ^c   Kubo, A ^b   Tatsuno, T ^d  

^a UNIVERSITÉ LAVAL   (Canada)

^b KYOTO UNIVERSITY   (Japan)

^c Yutaka Seimitsu Kogyo Ltd   (Japan)

^d Asano Gear Co Ltd   (Japan)

Author keywords

[No Author keywords available]

Indexed keywords

ALGORITHMS; GEAR CUTTING; GEAR MANUFACTURE; KINEMATICS; SURFACE PROPERTIES;

HYPOID GEARS;

GEAR TEETH;

EID: 0032166791     PISSN: 10500472     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.2829170     Document Type: Article

References (12)

1. Gosselin C., Shiono Y., Nonaka T., Kubo A., “A Computer Based Approach Aimed at Reproducing Master Spiral Bevel and Hypoid Pinions and Gears,” AGMA Paper 96FTM1.
2. Gosselin C., Cloutier L., Brousseau J., “Tooth Contact Analysis of High Conformity Spiral Bevel Gears,” JSME MPT 1991, Hiroshima.
3. Gosselin C., Cloutier L., Nguyen Q. D., “The Influence of the Kinematical Motion Error on the Loaded Transmission Error of Spiral Bevel Gears,” AGMA Paper 92FTM10, 1992.
4. Baxter M. L., “Exact Determination of Tooth Surfaces for Spiral Bevel and Hypoid Gears,” AGMA Paper 139.02, 1966.
5. Litvin F. L., Zhang Y., Kieffer J., “Identification and Minimization of Deviations of Real Tooth Surfaces,” ASME JOURNAL OF MECHANICAL DESIGN, Vol. 113, Mar. 1991.
6. Krenzer T. J., “Computer Aided Corrective Machine Settings for Manu-facturing Bevel and Hypoid Gears,” AGMA Paper 84FTM4, 1984.
7. Krenzer T. J., Knebel R., “Computer Aided Inspection of Bevel and Hypoid Gears,” SAE Paper 831266, 1983.
8. Stadtfeld H. J., “Handbook of Bevel and Hypoid Gears,” Rochester Institute of Technology, 1993.
9. The Gleason Works, “Tooth Bearing Development on Spiral Bevel and Hypoid Gears,” SD 6083A, Sept. 1967.
10. Litvin F. L, Zheng Y., Lundy M., “Determination of Settings of a Tilted Head Cutter for Generation of Hypoid and Spiral Bevel Gears,” 1989 ASME PTG.
11. Zhang Y., Litvin F. L, & et al., “Computerized Analysis of Meshing and Contact of Gear Real Tooth Surfaces,” ASME JOURNAL OP MECHANICAL DESIGN, Vol. 116, Sept. 1994.
12. Remond D., Jean Y., Gosselin C., “Practical Performances in High Speed Measurement of Gear Transmission Error Using Optical Encoders,” Cancam 1997 Proceedings, p. 141, June, 1997.