Commutation torque ripple minimization for permanent magnet synchronous machines with Hall effect position feedback

IEEE Transactions on Energy Conversion

Volumn 13, Issue 3, 1998, Pages 257-262

  Batzel, Todd D ^b   Lee, Kwang Y ^a,b  

^a IEEE

^b The Pennsylvania State University   (United States)

Author keywords

Hall effect sensor; Permanent magnet synchronous motor; Sensorless commutation; Torque ripple

Indexed keywords

COMPUTER SIMULATION; ELECTRIC COMMUTATION; ELECTRIC CURRENTS; ELECTRIC EXCITATION; FEEDBACK; HALL EFFECT DEVICES; PERMANENT MAGNETS; ROTORS (WINDINGS); SENSORS; STATORS; TORQUE CONTROL; WAVEFORM ANALYSIS;

COMMUTATION TORQUE RIPPLE; HALL EFFECT SENSORS; PERMANENT MAGNET SYNCHRONOUS MOTORS (PMSM); SINUSOIDAL FLUX DISTRIBUTIONS;

SYNCHRONOUS MOTORS;

EID: 0032166287     PISSN: 08858969     EISSN: None     Source Type: Journal    
DOI: 10.1109/60.707605     Document Type: Article

References (11)

1. K.J. Binns, "Permanent Magnet Machines" in Nasar, S.A. (Ed.) Handbook of Electrical Machines, McGraw-Hill, New York, 1987.
2. P. Pillay and R. Krishnan, "Application characteristics of permanent magnet synchronous and brushless DC motors for servo drives," IEEE Trans. on Ind. Appl., vol.27, no.5, pp. 986-996, September-October 1991.
3. B. Drafts, "Selecting Hall effect devices for BLDC motor commutation," Power Conversion & Intelligent Motion, vol. 22, no. 5, pp. 55-61, May 1996.
4. T.M. Jahns, "Torque production in permanent-magnet synchronous motor drives with rectangular current excitation," IEEE Trans. on Ind. Appl., vol. 20, pp. 803-813, April 1984.
5. S. Vlahu,"New brushless AC servo drive uses isolated gate bipolar power transistors and a CPU to obtain high dynamic performance with exceptionally high reliability and efficiency," Proc. Ind. Appl. Society Annual Meeting, pp. 685-690, 1990.
6. T. Liu and C. Cheng, "Adaptive control for a sensorless brushless permanent-magnet synchronous motor drive," IEEE Trans. on Aerospace and Electronic Sys. vol. 30, no. 3, pp. 900-909, July 1994.
7. S. Matsui, "Sensorless operation of brushless DC motor drives," IECON Proceedings vol. 2, pp. 739-744, 1993.
8. A. Consoli, "Sensorless operation of brushless DC motor drives," IEEE Trans. on Industrial Electronics vol. 41, no. 1,Pp. 91-95, Feb. 1994.
9. R. Wu, G.R. Slemon, "A permanent magnet motor drive without a shaft sensor," IEEE Trans. on Ind. Appl. vol. 27, no. 5, pp. 1005-1011, 1991.
10. J.S. Kim and S.K. Sul, "New aproach for high performance PMSM drives without rotational position sensors," IEEE Applied Motion Conf. And Expo. pp. 381-386, 1995.
11. P.C. Krause and O. Wasynzuk, Electromechanical Motion Devices, New York, McGraw-Hill, 1989.