Prediction of liquid filmdryout in two-phase annular-mist flow in a uniformly heated narrow tube development of analytical method under BWR conditions

Journal of Nuclear Science and Technology

Volumn 35, Issue 9, 1998, Pages 643-653

  Utsuno, Hideaki ^a,b   Kaminaga, Fumito ^b  

^a HITACHI LTD   (Japan)

^b IBARAKI UNIVERSITY   (Japan)

Author keywords

Annular mist flow; BWR type reactors; Critical heat flux; Deposition; Droplets; Entrainment; Heated tube; Liquid film dryout; Repository; Sweden; Three fluid streams; Tight lattice; Waste; sp hard rock laboratory

Indexed keywords

ENERGY CONSERVATION; HEAT FLUX; MASS TRANSFER; TWO PHASE FLOW;

CRITICAL HEAT FLUX; LIQUID FILM DRYOUT; THREE FLUID STREAMS; TIGHT LATTICE; TWO PHASE ANNULAR MIST FLOW; UNIFORMLY HEATED NARROW TUBE DEVELOPMENT;

BOILING WATER REACTORS;

EID: 0032155870     PISSN: 00223131     EISSN: None     Source Type: Journal    
DOI: 10.1080/18811248.1998.9733920     Document Type: Article

References (31)

1. Takeda, R., Aoyama, M., Moriwaki, M., Uchikawa, S., Yokomizo, O., Ochiai, K.: General features of resource-renewable B WR (RBWR) and scinario of long-term en- ergy supply, Ptoc. Int. Conf. on Evaluation of Emerging Nucl. Fuel Cycle Systems (Global-’95), Versailles, pp. 938-945 (1995).
2. Yamashita, J., Mochida, T.: Development of a high-conversion boiling water reactor, Nucl. Technol., 96, 20-28 (1991).
3. Macbeth, R. V.: Burn-out analysis, part 5, Examination of published world data for rod bundle, AEEW-R358, (1964).
4. Bertoletti, P. G., et al: Heat transfer crisis with steam-water mixtures, Energ. Nucl., 12 3, 121-172 (1965).
5. Biasi, L., et al.: Studies on burnout, part 3, A new correlation for round ducts and uniform heating and its comparison with world data, Energ. Nucl., 14 9, 530-536 (1967).
6. 2 (100-2500psia), AEEW-R789, (1972).
7. Katto, Y.: Critical heat flux of forced convection boiling in uniformly heated vertical tubes (correlation of CHF in HP-regime and determination of CHF-regime map), Int. J. Heat Mass Transfer, 23, 1573—1580 (1980).
8. Reddy, D. G., Fighetti, C. F.: Parametric study of CHF data, volume 2, A generalized subchannel CHF correlation for PWR and BWR fuel assemblies, EPRI-NP-2609-Vol. 2, (1983).
9. Hewitt, G. F., Hall-Taylor, N. S.: “Annular Two-Phase Flow”, Pergamon Press, Oxford, (1970).
10. Paleev, I. I., Filippovich, B. S.: Phenomena of liquid transfer in two-phase dispersed annular flow, J. Heat Mass Transfer, 9, 1089-1093 (1966).
11. Ishii, M., Mishima, K.: Correlation for liquid entrain-ment in annular two-phase flow of low-viscous fluid, ANL/RAS/LWR 81-2, (1981).
12. Owen, D. G., Hewitt, J. M.: A proposed entrainment correlation, AERE-R12279, (1986).
13. Namie, S., Ueda, T.: Droplet transfer in annular mist flow, part 1, Experiment of droplet concentration and velocity, Bull. JSME, 15 90, 1568-1580 (1972).
14. Namie, S., Ueda, T.: Droplet transfer in annular mist flow, part 2, Prediction of droplet transfer rate, Bull. JSME, 16 94, 752-764 (1973).
15. Singh, K., et al.: Liquid film flow rates in two-phase flow of steam and water at 1000 lb./sq. in. abs., AIChE J., 15 1, 51-56 (1969).
16. 2), AERE-RG293, (1970).
17. Wurtz, J.: An experimental and theoretical investigation of annular steam-water flow in tubes and annuli at 30 to 90 bar, Riso Rep. No. 372, (1978).
18. Bennett, A. W., et al: Studies of burnout in boiling heat transfer to water in round tubes with non-uniform heating, AERE-R507G, (1966).
19. Hewitt, G. F., et al: Determination of rate of deposition of droplets in a heated tube with steam-water flow at 1000 psia, AERE-R6118, (1969).
20. Bennett, A. W., et al: Measurement of liquid film flow rates at 1000 psia in upward steam water flow in a vertical heated tube, AERE-R5809, (1969).
21. 2), AERE-R6294, (1970).
22. Bennett, A. W., et al.: Measurements of burnout heat flux in uniformly heated round tubes at 1000 psia, AERE-R5055, (1965).
23. Dell, F. R., et al: Burnout heat flux measurements in a long tube, AERE-M2216, (1969).
24. Thompson, B., Macbeth, R. V.: Boiling water heat transfer burnout in uniformly heated round tubes; A comparison of world data with accurate correlations, AEEW-R35G, (1964).
25. Ishii, M., Grolmes, M. A.: Inception criteria for droplet entrainment in two-phase concurrent film flow, AIChE J., 21 2, 308-318 (1975).
26. Ueda, T.: Entrainment rate and size distribution of entrained droplets in annular two-phase flow, Bull. JSME, 22, 1258 (1979).
27. Kataoka, I., Ishii, M.: Mechanism and correlation of droplet entrainment and deposition in annular two-phase flow, NUREG/CR-2885, ANL-82-44, (1982).
28. Sugawara, S.: Droplet deposition and entrainment modeling based on the three-fluid model, Nucl. Eng. Des., 122, 67-84 (1990).
29. Whalley, P. B., et al.: The calculation of critical heat flux in forced convection boiling, Proc. 5th Int. Heat Transfer Conf, Tokyo, Vol. IV, pp. 290-294 (1974).
30. Zuber, N., Findley, J. A.: Average volumetric concentration in two-phase flow systems, J. Heat Transfer, 87, 453-468 (1965).
31. Ishii, M.: One-dimensional drift-flux model and constitutive equations for relative motion between phases in various two-phase flow regimes, ANL-77-47, (1977).