Calculation of dryout and post-dryout heat transfer for tube geometry

International Journal of Multiphase Flow

Volumn 24, Issue 2-7, 1998, Pages 319-334

  Hoyer, Norbert ^a  

^a Scandpower Petroleum Technology AS   (Norway)

Author keywords

Annular flow; Dryout model; Post dryout heat transfer

Indexed keywords

CALCULATIONS; EVAPORATION; FILMS; HEAT FLUX; HEAT TRANSFER; MATHEMATICAL MODELS; TUBES (COMPONENTS);

FILM EVAPORATION; THREE FIELD ANNULAR FLOW MODEL;

TWO PHASE FLOW;

EID: 0032010654     PISSN: 03019322     EISSN: None     Source Type: Journal    
DOI: 10.1016/s0301-9322(97)00057-8     Document Type: Article

References (29)

1. Abel-Larson, H., Olsen, A., Miettinen, J., Siikonen, Rasmussen, J., Sjöberg, A. and Becker, K. (1985) Heat transfer correlations in nuclear reactor safety calculations. NKA (Nordic Liaison Committee for Atomic Energy), SÅK-5, ISBN 87-550-1109-8.
2. Becker, K. M., Ling, C. H., Hedberg, S. and Strand, G. (1983) An experimental investigation of post dryout heat transfer. Department of Nuclear Reactor Engineering, Royal Institute of Technology, KTH-NEL-33, Sweden.
3. Becker, K. M., Askeljung, P., Hedberg, S., Söderquist, B. and Kahlbom, U. (1992) An experimental investigation of the influence of axial heat flux distributions on post dryout heat transfer for flow of water in vertical tubes. Department of Nuclear Reactor Engineering, Royal Institute of Technology, KTH-NEL-54, Sweden.
4. Bendiksen, K. H., Malnes, D., Moe, R. and Nuland, S. (1989) The dynamic two-fluid model OLGA: Theory and application. J. Petrol. Technol., SPE 19451.
5. Bennet, A. W., Hewitt, G. F., Kearsey, H. A., Keeys, R. K. F. and Pulling, D. J. (1966) Studies of burnout in boiling heat transfer to water in round tubes with non-uniform heating. AERE-R5076.
6. Bishop, A. A., Sandberg, R. O. and Tong, L. S. (1965) Forced convection heat transfer at high pressure after the critical heat flux. ASME-65-HT-31.
7. Bricard, P. and Souyri, A. (1995) Understanding and modelling DNB in forced convective boiling: a critical review. Proceedings of Two-Phase Flow Modelling and Experimentation, Rome, Italy.
8. Celata, G. P., Cumo, M. and Mariani, A. (1994) Assessment of correlations and models for the prediction of CHF in water subcooled flow boiling. Int. J. Heat Mass Transfer 37, 237-255.
9. Colburn, A. P. (1933) Method of correlating forced convective heat transfer data and a comparison with fluid friction. Trans. Am. Inst. Chem. Engng 29, 174-210.
10. Dittus, F. W., Boelter, L. M. K. (1930) Heat transfer in automobile radiators of the tubular type. Univ. California Publs, Vol. 2, pp. 443-461.
11. Dallman, J. C., Barclay, G. J. and Hanratty, T. J. (1979) Interpretation of entrainment measurements in annular gas-liquid flows. Two-Phase Momentum, Heat and Mass Transfer, ed. F. Durst, G. V. Tsiklauri and N. H. Afgan, McGraw-Hill.
12. Govan, A. (1990) Modelling of vertical annular and dispersed two-phase flows. PhD Thesis, Imperial College, University of London.
13. Hadaller, G. and Banerjee, S. (1969) Heat transfer to superheated steam in round tubes. Atomic Energy of Canada Limited, Pinawa, Manitoba, Internal Report WDI-147.
14. Heineman, J. B. (1960) An experimental investigation of heat transfer to superheated steam in round and rectangular channels. Argonne National Laboratories ANL-6213.
15. Hoyer, N. (1994) MONA, A 7-equation transient two-phase flow model for LWR dynamics. Proceedings of the International Conference on New Trends in Nuclear System Thermohydraulics, Vol. 1, pp. 271-280.
16. Hoyer, N. (1995) Validation of the transient two-phase flow model MONA against density wave oscillations. Proceedings of the International Symposium. Two-Phase Flow Modelling and Experimentation, Vol. 2, pp. 943-949.
17. Ishii, M. (1977) One-dimensional drift-flux model and constitutive equations for relative motion between phases in various two-phase flow regimes. ANL-77-47.
18. Katto, Y. (1994) Critical heat flux. Int. J. Multiphase Flow 20, 53-90.
19. Kutateladze, S. S. and Borishanskii, V. M. (1966) A Concise Encyclopedia of Heat Transfer. Pergamon, Oxford.
20. Lee, K. and Ryley, D. J. (1968) The evaporation of water droplets in superheated steam. J. Heat Transfer, 445-451.
21. Milashenko, V. I., Nigmatulin, B. I., Petukhov, V. V. and Trubkin, N. I. (1989) Burnout and distribution of liquid in evaporative channels of various lengths. Int. J. Multiphase Flow 15, 393-402.
22. Sugawara, S. and Miyamoto, Y. (1990a) FIDAS: Detailed subchannel analysis code based on the three-fluid and three-field model. Nucl. Engng Des. 120, 147-161.
23. Sugawara, S. (1990b) FIDAS: Droplet deposition and entrainment modeling based on the three-fluid model. Nucl. Engng Des. 122, 67-84.
24. Srikantiah, G. (1995) The role of experiments in the development of sub-channel analysis codes for utility applications. The 3rd International Seminar on Subchannel Analysis, Stockholm, SKI report 95:16.
25. Wallis, G. B. (1969) One-dimensional Two-phase Flow. McGraw-Hill, NY.
26. Webb, S. W., Chen, J. C. and Sundaram, R. K. (1982) Vapor generation rate in non-equilibrium convective film boiling. 7th International Heat Transfer Conference, Munich, paper no. FB45.
27. Weisman, J. (1992) The current status of theoretically based approaches to the prediction of the critical heat flux in flow boiling. Nucl. Technol. 99, 1-21.
28. Whalley P. B., Hutchinson P. and Hewitt, G. F. (1974) The calculation of critical heat flux in forced convection boiling. 5th International Heat Transfer Conference, Tokyo, Paper B6.11.
29. Whalley, P. B. (1977) The calculation of dryout in a rod bundle. Int. J. Multiphase Flow 3, 501-515.