Quantitative assessment of extrinsic damage in rock materials

Rock Mechanics and Rock Engineering

Volumn 31, Issue 1, 1998, Pages 43-62

  Kim, D S ^a   McCarter, M K ^b  

^a HYUNDAI Engineering and Construction   (South Korea)

^b UNIVERSITY OF UTAH   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

CRACKS; DEFECTS; ENERGY DISSIPATION; ROCK MECHANICS; SHOCK WAVES; STRENGTH OF MATERIALS; ULTRASONIC EFFECTS;

SHOCK WAVE EFFECTS;

ROCKS;

EID: 0031707960     PISSN: 07232632     EISSN: None     Source Type: Journal    
DOI: 10.1007/s006030050008     Document Type: Article

References (26)

1. Annual Book of ASTM Standards, Subject Index, Alphanumeric List (1990): ASTM Designations C769-80, D2845-83, D2938-79, D3148-80, E111-82, E251-86, E1237-88.
2. Brinkman, J. R. (1987): Separating shock wave and gas expansion breakage mechanism. In: Proc., Second Int. Symp Rock Fragmentation by Blasting, Society for Experimental Mechanics, Fourney, W. L., Dicky, R. D. (Eds.), Bethel, 6-15.
3. Davies, R. M. (1948): A critical study of the Hopkinson pressure bar. Proc. R. Soc. Lond. A 240, 375-457.
4. Fogelson, D. E., Duvall, W. I., Atchison, T. C. (1959): Strain energy in explosion-generated strain pulses. U.S. Bureau of Mines, RI 5514.
5. Hakalehto, K. O. (1967): A study of the dynamic behavior of rock using the Hopkinson split bar method. M. S. Thesis, University of Minnesota, USA.
6. Hawkes, I., Mellor, M. (1970): Uniaxial testing in rock mechanics laboratories. Eng. Geol. 4, 177-285.
7. Holmberg, R., Mäki, K. (1981): Case example of blasting damage and its influence on slope stability. Third Int. Conf. Stability in Surface Mining, Brawner, C. O. (Ed.), Vancouver, 773-793.
8. Hopkinson, B. (1914): A method of measuring the pressure produced in the detonation of high explosives or by the impact of bullets. Phil. Trans. R. Soc. Lond. A 213, 437-456.
9. Hult, J. (1974): Creep in continua and structures. Topics in Applied Continuum Mechanics Symp. Zeman, J. L., Ziegler, F. (Eds.), Vienna, Springer Wien New York, 137-155.
10. ISRM Suggested Method (1979): Determining water content, porosity, density, absorption and related properties and swelling and slake-durability index properties. Int. J. Rock Mech. Min. Sci. Geomech. Abstr. 16(2), 141-156.
11. Janach, W. (1976): The role of bulking in brittle failure of rocks under rapid compression. Int. J. Rock Mech. Min. Sci. Geomech. Abstr. 13, 177-186.
12. Kachanov, L. M. (1986): Introduction to continuum damage mechanics. Martinus Nijhoff Publ., Dordrecht.
13. Kim, D. S. (1993): The effect of shock-induced damage on comminution of rock materials. Dissertation, University of Utah, Salt Lake City, Utah, U.S.A.
14. Kolsky, H. (1949): An investigation of the mechanical properties of materials at very high rates of loading. Proc. Phys. Soc. B 62, 676-700.
15. Lemaitre, J. (1984): How to use damage mechanics. Nucl. Eng. Des. 80, 233-245.
16. Lindholm, U. S. (1990): Experimental mechanics-new challenges in micromechanics. Mech. Mater. 10, 31-42.
17. Lindholm, U. S., Yeakley, L. M. (1968): High strain-rate testing: tension and compression. Exp. Mech. (1), 1-19.
18. Lundberg, B. (1976): A split Hopkinson bar study of energy absorption in dynamic rock fragmentation. Int. J. Rock Mech. Min. Sci. Geomech. Abstr. 13, 187-197.
19. Mäki, K., Holmberg, R. (1980): Rock damage from crater blasting of a raise. In Swedish, SveDeFo, Report DS 1980, Stockholm.
20. 3/second. Int. J. Rock Mech. Min. Sci. 7, 527-535.
21. Roblee, P. P. N., Stokoe, K. H., II (1989): Changes in seismic measurements with blast induced blasting: a field experiment. Proc. 30th U.S. Rock Mech. Symp., West Virginia University, Morgantown, 19-22.
22. Sharpe, W. N. Jr., Hoge, K. G. (1972): Specimen strain measurement in the split-Hopkinson-pressure-bar experiment. Exp. Mech. (12), 570-574.
23. Timoshenko, S. P., Goodier, J. N. (1970): Theory of elasticity. McGraw-Hill, New York.
24. Walsh, J. B., Brace, W. F. (1966): Elasticity of rock: a review of some recent theoretical studies. Felsmechanik 4 (4), 283-297.
25. Wu, P. P. (1971): The split Hopkinson bar method of rock testing. M.S. Thesis, Colorado School of Mines.
26. Yamaguchi, U. (1970): The number of test-pieces required to determine the strength of rock. Int. J. Rock Mech. Min. Sci. 7, 209-227.