Interfacial characteristics of composites fabricated by laminated object manufacturing

Composites Part A: Applied Science and Manufacturing

Volumn 29, Issue 9-10, 1998, Pages 1165-1174

  Klosterman, Donald ^a   Chartoff, Richard ^a   Graves, George ^a   Osborne, Nora ^a   Priore, Brian ^a  

^a UNIVERSITY OF DAYTON   (United States)

Author keywords

Ceramic matrix composites (CMCs); Low cost manufacturing; Rapid prototyping

Indexed keywords

ADHESION; CERAMIC MATRIX COMPOSITES; COST EFFECTIVENESS; EPOXY RESINS; GLASS FIBER REINFORCED PLASTICS; HIGH TEMPERATURE OPERATIONS; INTERFACES (MATERIALS); RAPID PROTOTYPING; SILICON CARBIDE;

LAMINATED OBJECT MANUFACTURING (LOM);

LAMINATED COMPOSITES;

EID: 0031623768     PISSN: 1359835X     EISSN: None     Source Type: Journal    
DOI: 10.1016/S1359-835X(98)00088-8     Document Type: Article

References (7)

1. Laminated Object Manufacturing and LOM are trademarks of Helisys, Inc., 24015 Garnier St., Torrance, CA, 90505, USA.
2. Chartoff, R. and Klosterman, D., Low cost automated fabrication of ceramic and composite tooling using laminated object manufacturing, Proceedings of the 28th International SAMPE Technical Conference, Seattle, WA, November 5, 1996.
3. Klosterman, D., Chartoff, R., Osborne, N., Graves, G., Lightman, A., and Han, G., Laminated object manufacturing (LOM) of advanced ceramics and composites, Proceedings of Seventh International Conference on Rapid Prototyping, University of Dayton and Stanford University, San Francisco, CA, April 1997.
4. Klosterman, D., Chartoff, R., et al., LOM, direct fabrication of ceramics and CMCs, American Ceramic Society Bulletin, manuscript in development.
5. Klosterman, D., Chartoff, R., et al., Development of a curved layer LOM process for advanced materials and composites, Rapid Prototyping Journal, manuscript in development.
6. Klosterman, D., Chartoff, R. and Priore, B., Direct fabrication of structural polymer composites via laminated object manufacturing, Proceedings of the Seventh International Conference on Rapid Prototyping, University of Dayton and Stanford University, San Francisco, April 31, 1997.
7. Klosterman, D., Chartoff, R., Priore, B., Osborne, N. and Graves, G., Automated fabrication of structural polymer and ceramic matrix composites via laminated object manufacturing (LOM), Proceedings of the 42nd International SAMPE Symposium and Exhibition, Anaheim, CA, May 5-8, 1997.