Design of saw expander and compressor on litao3 for a tcdma spread spectrum system

IEEE Transactions on Microwave Theory and Techniques

Volumn 45, Issue 12 PART 2, 1997, Pages 2486-2492

  Weigel, Robert ^a  

^a JOHANNES KEPLER UNIVERSITY LINZ   (Austria)

Author keywords

Spread spectrum communication; Surfaceacoustic waves; Tapped delay lines; TCDMA

Indexed keywords

ACOUSTIC SURFACE WAVE FILTERS; BANDWIDTH; CELLULAR RADIO SYSTEMS; DIGITAL COMMUNICATION SYSTEMS; LITHIUM COMPOUNDS; SPREAD SPECTRUM COMMUNICATION; SUBSTRATES; TIME DIVISION MULTIPLEXING; TRANSDUCERS;

CODE DIVISION MULTIPLE ACCESS (CDMA); INTERDIGITAL TRANSDUCERS; MINIMUM SHIFT KEYING (MSK); TAPPED DELAY LINES;

ACOUSTIC DELAY LINES;

EID: 0031354718     PISSN: 00189480     EISSN: None     Source Type: Journal    
DOI: 10.1109/22.643864     Document Type: Article

References (21)

1. M. K. Simon, J. K. Omura, R. A. Scholtz, and B. K. Levitt, Spread Spectrum Communications Handbook. New York: McGraw-Hill, 1994.
2. M. Nakagawa and T. Hasegawa, "Spread spectrum for consumer applications: Applications of spread spectrum communications in Japan," IEICE Trans., vol. E74, pp. 1093-1102, 1991.
3. I. J. Wickelgren, "Local-area networks go wireless," IEEE Spectrum, pp. 34-40, Sept. 1996.
4. R. C. Dixon, Spread Spectrum Systems with Commercial Applications. New York: Wiley, 1994.
5. R. Weigel, A. Fauter, P. Russer, L. Reindl, and F. Seifert, "On the design of moderate time-bandwidth SAW convolver for indoor and mobile radio applications," in Proc. IEEE 5th Int. Symp. Personal Indoor and Mobile Radio Communications (PIRMC'94), The Hague, The Netherlands, 1994, pp. 379-383.
6. K. Tsubouchi, H. Nakase, A. Namba, and K. Masu, "Full duplex transmission operation of a 2.45-GHz asynchronous spread spectrum modem using a SAW convolver," IEEE Trans. Ultrason., Ferroelect., Freq. Contr., vol. 40, pp. 478-4182, 1993.
7. H. Nakase, T. Kasai, Y. Nakamura, K. Masu, and K. Tsubouchi, "One chip demodulator using RF front-end SAW correlator for 2.4 GHz asynchronous spread spectrum modem," in Proc. IEEE 5th Int. Symp. Personal, Indoor and Mobile Radio Communications (PIRMC'94), The Hague, The Netherlands, 1994, pp. 374-378.
8. T. Shiba, A. Yuhara, M. Moteki, Y. Ota, K. Oda, and K. Tsubouchi, "Low loss SAW matched filters with low sidelobe sequences for spread spectrum communications," in Proc. IEEE Ultrasonics Symp., Seattle, WA, 1995, pp. 107-112.
9. A. Fauter, L. Reindl, R. Weigel, P. Russer, and F. Seifert, "Miniaturized SAW convolver for indoor mobile communications," in Proc. IEEE Ultrasonics Symp., Baltimore, MD, 1993, pp. 73-77.
10. D. P. Morgan, Surface-Wave Devices for Signal Processing. Amsterdam, The Netherlands: Elsevier, 1985, ch. 10.
11. F. Moeller, A. Rabah, S. M. Richie, M. A. Belkerdid, and D. C. Malocha, "Differential phase shift keying direct sequence spread spectrum single SAW based correlator receiver," in Proc. IEEE Ultrasonics Symp., Cannes, France, 1994, pp. 189-193.
12. Z. Zhang, F. Seifert, and R. Weigel, "A SAW matched filter based spread spectrum technique for indoor multiple access systems," in IEEEMTT-S Dig., Orlando, FL, 1995, pp. 899-902.
13. Z. Zhang, F. Seifert, and R. Weigel, "Simulation of a UHF-band indoor wireless TCDMA system based on multipath fading radio channel modeling," in Proc. IEEE Microwave Systems Conf., Orlando, FL, 1995, pp. 243-246.
14. P. H. Carr, P. A. DeVito, and T. L. Szabo, "The effect of temperature and Doppler shift on the performance of elastic surface wave encoders and decoders," IEEE Trans. Sonics Ultrason., vol. SU-19, pp. 357-367, 1972.
15. Y. Takeuchi and K. Yamanouchi, "A low loss SAW matched filter using unidirectional transducers under the compensation method of temperature deviations," in Proc. IEEE Ultrasonics Symp., Seattle, WA, 1995, pp. 7-12.
16. C. Campbell, Surface Wave Devices and Their Signal Processing Applications. New York: Academic, 1989, ch. 6.
17. C. C. W. Ruppel, W. Ruile, G. Scholl, K. C. Wagner, and O. Männer, "Review of models for low-loss filter design and applications," in Proc. IEEE Ultrasonics Symp., Cannes, France, 1995, pp. 313-324.
18. A. Visintini and A. R. Baghai-Wadji, "Modular two-dimensional analysis of SAW-filters, Part 1: Theory," IEEE Trans. Ultrason., Ferroelect., Freq. Contr., vol. 39, pp. 61-72, 1992.
19. R. Weigel, C. Knorr, K. C. Wagner, L. Reindl, and F. Seifert, "MSK SAW tapped delay lines on LiTaOa with moderate processing gain for CDMA indoor and mobile radio applications," in Proc. IEEE Ultrason. Symp., Seattle, WA, 1995, pp. 167-170.
20. C. Knorr, "Entwicklung von SAW-Tapped Delay Lines für CDMAIndoor-Mobilfunkanwendungen," diploma thesis, Technical University of Munich, Germany (in German), 1995.
21. F. Kalabic, "Entwurf einer 127 chips SAW Tapped Delay Line für ein TCDMA SS-System," diploma thesis, Technical University of Vienna, Austria (in German), 1996.