An experimental investigation into the design and performance of hydrostatically loaded floating wear plates in gear pumps

Wear

Volumn 209, Issue 1-2, 1997, Pages 184-192

  Koc E ^a   Hooke, C J ^b  

^a CUKUROVA UNIVERSITY   (Turkey)

^b UNIVERSITY OF BIRMINGHAM   (United Kingdom)

Author keywords

Experimental; Floating wear plates; Gear pumps; Hydrostatically loaded

Indexed keywords

DESIGN; GEAR PUMPS; LOADS (FORCES); PERFORMANCE; PLATES (STRUCTURAL COMPONENTS);

FLOATING WEAR PLATE; HYDROSTATIC LOAD;

WEAR OF MATERIALS;

DESIGN; PLATES; PUMPS-GEAR;

EID: 0031214511     PISSN: 00431648     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0043-1648(97)00021-5     Document Type: Article

References (10)

1. R.N. Henke, Internal leakage in gear pumps, Appl. Hydraul. 8 (1955) 63-66.
2. C.J. Hooke, E. Koç, End plate balance in gear pumps, Proc. Inst. Mech. Eng. Lon. 198B (1984) 55-60.
3. E. Koç, C.J. Hooke, End lubrication and sealing in gear pumps with fixed end plates, J. Fluid Control 18 (3) (1988) 52-69.
4. E. Koç, C.J. Hooke, The lubrication and sealing of floating end plates in gear pumps, J. Natl Conf. Fluid Power 1 (1988) 97-115.
5. E. Koç, C.J. Hooke, The surface non-flatness effect on the design of bush type bearings in high pressure pumps and motors, Wear 135 (1989) 29-39.
6. E. Koç, An investigation into the performance of hydrostatically loaded end-plates in high pressure pumps and motors; movable plate design, Wear 141 (1991) 249-265.
7. E. Koç, Analytical and experimental investigation into the sealing and lubrication mechanisms of the gear ends in pumps, Wear 135 (1989) 79-94.
8. C.J. Hooke, Y.P. Kakoullis, On-line measurement of film thickness, Inst. Mech. Eng. Conf. on Instrument and Computers for Cost Effective Fluid Power Testing, Institute of Mechanical Engineers, London, 1979, Paper C128179, pp. 51-59.
9. E. Koç, C.J. Hooke, K.Y. Li, Slipper balance in axial piston pumps and motors, Trans. ASME J. Tribol. 114 (1992) 766-772.
10. E. Koç, C.J. Hooke, Investigation into the effects of orifice size, offset and overclamp ratio on the lubrication of slipper bearings, Tribol. Int. 29 (4) (1996) 299-305.