An analysis of the lubrication mechanisms of the bush-type bearings in high pressure pumps

Tribology International

Volumn 30, Issue 8, 1997, Pages 553-560

  Koc E ^a   Kurban, A O ^b   Hooke, C J ^c  

^a CUKUROVA UNIVERSITY   (Turkey)

^b ERCIYES UNIVERSITY   (Turkey)

^c UNIVERSITY OF BIRMINGHAM   (United Kingdom)

Author keywords

Bearings; Bush; Gear pumps; Hydraulic balance

Indexed keywords

BEARINGS (MACHINE PARTS); BUSHINGS; GEAR PUMPS; GEARS; HYDRAULIC MACHINERY;

BUSH BEARINGS; HIGH PRESSURE PUMPS;

LUBRICATION;

EID: 0031199616     PISSN: 0301679X     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0301-679X(96)00075-8     Document Type: Article

References (10)

1. Hooke C. J., Foster K. and Madera G., A note on the effect of shaft and casing stiffness on the port plate lubricating film of a particular slipper pad axial piston pump. In Proceedings of the 4th International Fluid Power Symposium. 1975, BHRA, pp. B2, 21-28.
2. Hooke C. J. and Kakoullis Y. P. The lubrication of slippers in axial piston pumps, Fluidics Quarterly 1979, USA, 12, 1, 61-75
3. Hooke C. J. and Kakoullis Y. P., The effect of centrifugal load and ball friction on the lubrication of slippers in axial piston pumps. In Proceedings of the 6th International Fluid Power Symposium. 1981, pp. 179-181.
4. Hooke C. J. and Koç E. End plate balance in gear pumps, Proceedings of the Institution of Mechanical Engineers 1984, Vol. 198, No. 2. Part B, Feb, 55-60
5. Koç E. Analytical and experimental investigation into the sealing and lubrication mechanisms of the gear ends in pumps, Wear 1989, 135, 79-94
6. Koç E. and Hooke C. J. The surface non-flatness effect on the design of bush type bearings in high pressure pumps and motors, Wear 1989, 135, 29-39
7. Iboshi N. and Yamagoghi A. Characteristics of a slipper bearing for swash plate type axial piston pumps and motors (1st Report, Theoretical Analysis), Bulletin of the Japanese Society of Mechanical Engineers 1982, 210, 1291-1930
8. Koç E. and Hooke C. J. Investigation into the effects of orifice size, offset and over-clamp ratio on the lubrication of slipper bearings, Tribology International 1996, 29, 4, 299-305
9. Hooke C. J. and Kakoullis Y. P. On-line measurement of film thickness. Proc. Conference on instruments and computers for cost effective fluid power testing, Institution of Mechanical Engineers 1979, Paper C128/79, pp. 51-59.
10. Lindley P. B., Design considerations for sealing rings. In Rubbers Handbook, Design Engineering Series, ed. L. R. Mernagh. Morgan Grampian, 1969, 54-62.