Experimental mass (heat) transfer in and near a circular hole in a flat plate

International Journal of Heat and Mass Transfer

Volumn 40, Issue 10, 1997, Pages 2431-2443

  Cho, H H ^a   Jabbari, M Y ^b   Goldstein, R J ^c  

^a Yonsei University   (South Korea)

^b SAGINAW VALLEY STATE UNIVERSITY   (United States)

^c University of Minnesota   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

ASPECT RATIO; BOUNDARY LAYER FLOW; LAMINAR FLOW; MASS TRANSFER; PLATES (STRUCTURAL COMPONENTS); REYNOLDS NUMBER; SUBLIMATION; TURBULENT FLOW; WALL FLOW;

HOLE TO HOLE SPACING; LAMINAR SEPARATION; NAPHTHALENE SUBLIMATION TECHNIQUE; TURBULENT REATTACHMENT FLOW; WEAK ENTRAINMENT FLOW VELOCITY;

HEAT TRANSFER;

HEAT TRANSFER; PLATES;

EID: 0031195104     PISSN: 00179310     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0017-9310(96)00270-0     Document Type: Article

References (15)

1. Cho, H. H., Heat/mass transfer flow through an array of holes and slits. Ph.D. thesis, University of Minnesota, Minneapolis, MN, 1992.
2. Cho, H. H. and Goldstein, R. J., Heat (mass) transfer and film cooling effectiveness with injection through discrete holes - part I : within holes and on the back surface. Journal of Turbomachinery, 1995, 117, 440-450.
3. Gurdal, U., Heat transfer at an upstream-facing surface washed by fluid en route to an aperture in the surface. M.S. thesis, University of Minnesota, Minneapolis, MN, 1980.
4. Lichtarowicz, A., Duggins, R. K. and Markland, E., Discharge coefficients for incompressible non-cavitating flow through long orifices. Journal of Mechanical Engineering Science, 1965, 7, 210-219.
5. Boelter, L. M. K., Young, G. and Iversen, H. W., Distribution of heat-transfer rate in the entrance section of a circular tube. NACA TN - 1451, 1948.
6. Mills, A. F., Experimental investigation of turbulent heat transfer in the entrance region of a circular conduit. Journal of Mechanical Engineering Science, 1962, 4, 63-77.
7. Petukhov, B. S., Heat transfer and friction in turbulent pipe flow with variable physical properties. In Advances in Heat Transfer, Vol. 6, ed. J. P. Hartnett and T. F. Irvine. Academic Press, New York, 1970, pp. 503-564.
8. Al-Arabi, M., Turbulent heat transfer in the entrance region of a tube. Heat Transfer Engineering, 1982, 3, 76-83.
9. Lloyd, S. and Brown, A., Fluid flow and heat transfer characteristics in the entrance region of circular pipes. ASME paper 85-GT-121, 1985.
10. Goldstein, R. J. and Cho, H. H., A review of mass transfer measurements using naphthalene sublimation. Experimental Thermal and Fluid Science, 1995, 10, 416-434.
11. Ambrose, D., Lawrenson, J. and Sparke, C. H. S., The vapor pressure of naphthalene. Journal of Chemical Thermodynamics, 1975, 7, 1173-1176.
12. Kline, S. J. and McClintock, F. A., Describing uncertainty in single-sample experiments. Mechanical Engineering, 1953, 75, 3-8.
13. Goldstein, R. J., Eriksen, V. L., Olson, R. M. and Eckert, E. R. G., Laminar separation, reattachment and transition of the flow over a downstream-facing step. Journal of Basic Engineering, 1970, 92, 732-741.
14. Eaton, J. K. and Johnston, J. P., A review of research on subsonic turbulent flow reattachment. AIAA Journal, 1981, 19, 1093-1100.
15. Kays, W. M. and Crawford, M. E., Convective Heat and Mass Transfer. McGraw-Hill, New York, 1994.