Pullout behavior of steel fibers from cement-based composites

Cement and Concrete Research

Volumn 27, Issue 6, 1997, Pages 925-936

  Shannag, M Jamal ^a   Brincker, Rune ^b   Hansen, Will ^c  

^a North Carolina State University   (United States)

^b AALBORG UNIVERSITY   (Denmark)

^c Department of Ecology and Evolutionary Biology   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

BRITTLENESS; FIBER REINFORCED METALS; INTERFACES (MATERIALS); MECHANICAL TESTING; MORTAR; STEEL; TOUGHENING; VOLUME FRACTION;

DENSIFIED SMALL PARTICLES (DSP) SYSTEMS; PULLOUT TESTING; STEEL FIBERS;

CEMENTS;

EID: 0031169994     PISSN: 00088846     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0008-8846(97)00061-6     Document Type: Article

References (22)

1. P.S. Shah and C. Ouyang, Mechanical behavior of fiber-reinforced cement-based composites, Journal of American Ceramic Society, 74(11), 2727-2738 (1991).
2. J.K. Kim, L.M. Zhou and Y.W. Mai, Interfacial and fiber pullout stresses, Part III. Journal of Materials Science 28, 3923-3930 (1993).
3. A.E. Naaman, G. Namur, J.M. Alwan and H. Najm, Fiber pullout and bond slip. I: analytical study; II: experimental validation, ASCE Journal of Structural Engineering, 117, 2769-2800, (1991).
4. H. Stang, Z. Li and S.P. Shah, Pull-Out Problem: Stress versus fracture mechanical approach. ASCE Journal of Engineering Mechanics, 116, 2136-2150 (1990).
5. J. Mandel, S. Wei and S. Said, Studies of the properties of the fiber-matrix interface in steel fiber reinforced mortar, ACI Materials Journal, 84, 101-109 (1987).
6. D.J. Pinchin and D. Tabor, Interfacial phenomena in steel fiber reinforced cement II: pullout behavior of steel wires. Cement Concrete Research, 8(2), 139-150 (1978).
7. R.J. Gray and C.D. Johnston, The effect of matrix composition on fiber/matrix interfacial bond shear strength in fiber reinforced mortar. Cement Concrete Research, 14(2), 285-296 (1984).
8. Y. Wang, V.C. Li and S. Baker, Analysis of synthetic fiber pullout from a cement matrix. Bonding in Cementitious Composites, MRS Symposium. Proc., Materials Research Society, 114, 159-165 (1988).
9. J.K. Morrison, S.P. Shah and Y.S. Jenq, Analysis of fiber debonding and pull-out in composites. J. Engrg. Mech., 114(2), 277-294 (1988).
10. H. Stang and S.P. Shah, Failure of fiber reinforced composites by pull-out fracture, Journal of Materials Science, 21(3), 953-957 (1986).
11. Z. Li, B. Mobasher and S.P. Shah, Characterization of interfacial properties in fiber reinforced cementitious composites, Journal of the American Ceramic Society, 74(9), 2156-2164, (1991).
12. V.S. Gopalaratnam and H.J. Abu-Mathkour, Investigation of the pull-out characteristics of steel fiber from mortar matrices, Proceedings, International Symposium on Fiber Reinforced Concrete, Madras, pp. 2.201-2.211, 1987.
13. N. Banthia and J. Trottier, Concrete reinforced with deformed steel fibers, Part I: Bond-Slip Mechanisms, ACI Materials Journal, 91, 435-446 (1994).
14. M. Shannag, Tensile behavior of fiber reinforced DSP cement, Ph.D. Thesis, Department of Civil and Environmental Engineering, University of Michigan, Ann Arbor, pp. 213, 1995.
15. M. Shannag, R. Brincker and W. Hansen, Interfacial (fiber-matrix Properties of High Strength Mortar (150 MPa) From Fiber Pullout, ACI Materials Journal, 93(5), 480-486 (1996).
16. A. Bentur, and S. Mindess, Fiber reinforced cementitious composites, Elsevier Science Publishing, pp. 430, 1990.
17. H.H. Bache, Densified cement ultra-fine particle-based materials CBL Report No. 40, Aalborg Portland, Aalborg, Denmark, pp. 87, 1981.
18. P. Balaguru and S. Shah, Fiber reinforced cementitious composites, McGraw-Hill Publishing Company Ltd., 1992.
19. M. Shannag, W. Hansen and R. Brincker, Interfacial debonding and sliding in brittle cement-matrix composites from steel fiber pullout tests, Symposium Proceedings Materials Research Society, Vol. 370, 1995.
20. M. Kawamura and S. Igrashi, Fracture toughness for steel fiber-cement paste interface zone, Journal of Materials for Civil Engineers, Vol. 4, No. 3, 1992.
21. D. A. Jone, McLeod, N.B. Milestone, Durability of DSP mortars exposed to conditions of wetting and drying, International Workshop on High Performance Concrete, Bangkok, Thailand (Paul Zia, ed.) November 1994, SP-159.
22. J.M. Alwan, A.E. Naaman and W. Hansen, Pullout work of steel fibers From cementitious composites: analytical investigation, Cement and Concrete Composites, 13, 247-255 (1991).