A simple algorithm for stamping circular plates by hemispherical punches

Journal of Materials Processing Technology

Volumn 68, Issue 1, 1997, Pages 33-38

  Kadkhodayan, M ^a   Zhang, L C ^a  

^a UNIVERSITY OF SYDNEY   (Australia)

Author keywords

Circular plate; Contact problem; Elastic plastic deformation; Sheet stamping

Indexed keywords

CIRCULAR PLATE; ELASTIC PLASTIC DEFORMATION; SHEET STAMPING;

ALGORITHMS; BENDING (DEFORMATION); PLASTIC DEFORMATION; PLATE METAL; PROBLEM SOLVING; PUNCHING; SHEET METAL; STRESS ANALYSIS; STRESS CONCENTRATION;

METAL STAMPING;

EID: 0031164693     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0924-0136(96)02524-1     Document Type: Article

References (8)

1. W. Johnson and A.N. Singh, Springback in circular blanks, Metallurgia, 47 (1980) 275-280.
2. T.X. Yu and W. Johnson, The press-brake bending of rigid/linear work-hardening plates, Int. J. Mech. Sci., 23 (1981) 307-318.
3. T.X. Yu, W. Johnson and W.J. Stronge, Stamping and springback of circular plates deformed in hemispherical dies, Int. J. Mech. Sci., 26 (1984) 131-148.
4. W.J. Stronge, M.P.F. Sutcliffe and T.X. Yu, Wrinkling of elastoplastic circular plates during stamping, Exp. Mech., 26 (1986) 345-353.
5. L.C. Zhang, T.X. Yu and R. Wang, Investigation of sheet metal forming by bending - part IV: bending and wrinkling of circular sheets pressed by a hemispherical punch, Int. J. Mech. Sci., 31 (1989) 335-348.
6. G. Lu and L.S. Ong, Study on the stamping of elastic plastic plates, J. Mater. Process. Manufact. Sci., 2 (1994) 305-314.
7. K. Kormi, D.C. Webb and R.A. Etheridge, FEM simulation of the pressing of a strip into a cylindrical die and of a circular plate into a hemispherical one and their comparison with experiment, J. Mater. Process. Technol., 42 (1994) 463-473.
8. M. Kadkhodayan and L.C. Zhang, A consistent DXDR method for elastic-plastic problems, Int. J. Numer. Meth. Eng., 35 (1995) 2413-2431.