Burr minimization in face milling: A geometric approach

Journal of Manufacturing Science and Engineering, Transactions of the ASME

Volumn 119, Issue 2, 1997, Pages 170-177

  Narayanaswami, R ^a   Dornfeld, D ^a  

^a UNIVERSITY OF CALIFORNIA   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

ALGORITHMS; COMPUTATIONAL GEOMETRY; COMPUTER AIDED DESIGN; DEBURRING; OPTIMIZATION;

BURR MINIMIZATION; FACE MILLING;

MILLING (MACHINING);

EID: 0031146873     PISSN: 10871357     EISSN: 15288935     Source Type: Journal    
DOI: 10.1115/1.2831092     Document Type: Article

References (9)

1. Gillespie, L. K., and Blotter, P. T., “The Formation and Properties of Machining Burr,” ASME Journal of Engineering for Industry, Vol. 98, No. 1, Feb., 1976, pp. 66-74.
2. Nakayama, K., and Arai, M., “Burr Formation in Metal Cutting,” Annals of the CIRP, Vol. 36, No. 1, 1987, pp. 33-36.
3. Chern, G. L., “Analysis of Burr Formation and Breakout in Metal Cutting,” PhD Dissertation, Univ. of California, Berkeley, Department of Mechanical Engineering, 1993.
4. Chern, G. L., and Dornfeld, D. A., “Burr/Breakout Development and Experimental Verification,” ASME Journal of Engineering Materials and Technology, submitted for publication.
5. Chern, G. L., and Dornfeld, D. A., “Analysis of.Burr Formation and Breakout Using a Scanning Electron Microscope Micro-Machining Stage,” ASME Journal of Engineering Materials and Technology, submitted for publication.
6. Girase, V., “The Framework for Minimization of Burr and Breakout Formation in Metal Cutting,” MS Report, Univ. of California, Berkeley, Department of Mechanical Engineering, 1992.
7. Konig, W., “Minimizing Burr Formation,” CIRP STC C Meeting, Edinburgh, 1993.
8. Kishimoto, W., Miyake, T., Yamamoto, A., Yamanaka, K., and Takano, K., “Study of Burr Formation in Face Milling,” Bulletin of JSPE, Vol. 15, No. 1, 1981, pp. 51-52.
9. Kitajima, K., Miyake, T., Yamamoto, A., and Tanaka, Y., “Study on Mechanism and Similarity of Burr Formation in Face Milling and Drilling,” Technology Reports of Kansai University, No. 32, 1990.