Modeling of heat recovery steam generator performance

Applied Thermal Engineering

Volumn 17, Issue 5, 1997, Pages 427-446

  Ong'iro, A ^a   Ugursal, V I ^a   Al Taweel, A M ^a   Walker, J D ^b  

^a DALHOUSIE UNIVERSITY   (Canada)

^b Deltak Unit of Jason Inc   (United States)

Author keywords

HRSG; Numerical model; Thermal hydraulic analysis

Indexed keywords

COMBINED CYCLE POWER PLANTS; ENTHALPY; FLOW PATTERNS; HEAT EXCHANGERS; HEAT FLUX; HEAT TRANSFER; NUMERICAL METHODS; PRESSURE; TEMPERATURE; THERMAL CONDUCTIVITY; WASTE HEAT UTILIZATION;

HEAT FLUX DISTRIBUTIONS; HEAT RECOVERY STEAM GENERATOR; STEAM QUALITY; THERMAL HYDRAULIC ANALYSIS;

STEAM GENERATORS;

EID: 0031130560     PISSN: 13594311     EISSN: None     Source Type: Journal    
DOI: 10.1016/S1359-4311(96)00052-X     Document Type: Article

References (20)

1. S. G. Hauser, D. K. Kreid and B. M. Johnson, Investigation of combined heat and mass from a wet heat exchanger: II experimental results. ASME JSME Thermal Engineering Joint Conference, Honolulu, HI, pp. 525-535, March (1983).
2. A. J. Chapman, Fundamentals of Heat Transfer. McMillan Publishing Co., New York (1984).
3. S. V. Patankar and D. B. Spalding, Computer analysis of the three dimensional flow and heat transfer in a steam generator. Forschung Ing. -Wes. 44, 47-52 (1978).
4. S. V. Patankar, Numerical Heat Transfer and Fluid Flow. McGraw-Hill Book Co., New York (1980).
5. S. V. Patankar and D. B. Spalding, Simultaneous Predictions of Flow Pattern and Radiation for Three Dimensional Flames, Heat Exchangers (Edited by N. M. Afgan and J. M. Beer), pp. 73-94. Hemisphere, New York (1974).
6. R. R. Dils and P. S. Follansbee, Heat transfer coefficients around cylinders in cross flow from combustor exhaust gases. J. Engng Power, 497-507 (1977).
7. Babcock and Wilcox, Steam: Its Generation and Use. Babcock and Wilcox Co., New York (1992).
8. S. V. Patankar and D. B. Spalding, A calculation procedure for heat, mass and momentum transfer in three dimensional parabolic flows. Int. J. Heat Mass Transfer 15, 1787 (1972).
9. A. Ong'iro, V. I. Ugursal, A. M. Al Taweel and G. La Jeunesse, Using ASPEN PLUS Shell to simulate the performance of gas turbines. In Proceedings of the ASME 1994 Engineering Systems Design and Analysis Conference, London, pp. 57-64, 4-7 July (1994).
10. DELTAK, HRSG Performance Data. DELTAK, Minneapolis, MN (1994).
11. S.W. Churchill, Comprehensive correlating equation for heat, mass and momentum transfer in a fully developed flow in smooth tubes. Ind. Eng. Chem. Fundam. 16(11), 109-116 (1977).
12. S. Kekac, The effect of temperature dependent fluid properties on convective heat transfer. In Handbook of Single Phase Convective Heat Transfer (Edited by S. Kekac, R. Shah and Wing Aung), Chapter 18. John Wiley and Sons, New York (1987).
13. J. R. Thom, Prediction of pressure drop during forced circulation boiling of water. Int. J. Heat Mass Transfer 7, 709-724 (1964).
14. J. G. Collier, Convective Boiling and Condensation. McGraw-Hill Book Co., New York (1972).
15. A. A. Zukauskas, Convective heat transfer in cross flow. In Handbook of Single Phase Convective Heat Transfer (Edited by S. Kekac, R. Shah and Wing Aung), Chapter 6. John Wiley and Sons, New York (1987).
16. E. S. Gaddis and V. Gnielinski, Equations for heat and mass transfer in turbulent pipe and channel flow. International Chemical Engineering 25(1), 1-15 (1985).
17. V. Gnielinski, New equations for heat and mass transfer in turbulent pipe and channel flow. International Chemical Engineering 16(2), 359-368 (1976).
18. V. V. Klimenko, A generalized correlation for two phase forced flow heat transfer. Int. J. Heat Mass Transfer 31, 541-552 (1988).
19. V. V. Klimenko, A generalized correlation for two phase forced flow heat transfer - second assessment. Int. J. Heat Mass Transfer 31, 2073-2087 (1988).
20. W. J. Marner and J. W. Suitor, A Survey of Gas Side Fouling in Industrial Heat Transfer Equipment, JPL Publication 83-74. Jet Propulsion Laboratory, Institute of Technology, Pasadena, CA (1984).