Analytical and experimental identification of nonlinearities in a single-nut, preloaded ball screw

Journal of Mechanical Design, Transactions of the ASME

Volumn 119, Issue 1, 1997, Pages 15-19

  Cuttino, J F ^a   Dow, T A ^b   Knight, B F ^c  

^a University of Alabama   (United States)

^b North Carolina State University   (United States)

^c Centers for Disease Control and Prevention   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

ACTUATORS; BALL BEARINGS; CONTROL NONLINEARITIES; FRICTION; LOADS (FORCES); MECHANICAL TESTING; MECHANICAL VARIABLES MEASUREMENT; NUTS (FASTENERS); PERFORMANCE; SHAFTS (MACHINE COMPONENTS); TORQUE; TORQUE MEASUREMENT;

ANGLE ROTATION FIXTURE; BALL SCREW ACTUATOR; NONLINEAR DISPLACEMENT RESPONSE; PRECISION LINEAR OPTIMIZATION TESTBED; SHAFT WINDUP;

SCREWS;

EID: 0031097343     PISSN: 10500472     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.2828782     Document Type: Article

References (11)

1. Bowden, F. P., and Tabor, D., 1964, Friction and Lubrication of Solids, Oxford, p. 318.
2. Cattaneao, C., 1938, “Sul Contatto di Due Corpi Elastici,” Accademia dei Lincei, Rendiconti, Series 6, Vol. XXVII.
3. Cultino, J. F., and Dow, T. A., 1991, “Linear Slide Actuators for Long Range Motion with Nanometer Accuracy,” Proceedings of the Precision Engineering Center, 1991 Annual Report, North Carolina State University.
4. Cultino, J. F., 1994, “Identification and Compensation of Nonlinear Effects in Precision Actuator Systems,” Ph.D. Dissertation, North Carolina State University, Raleigh, NC.
5. Cuttino, J. F., and Dow, T. A., 1995, “Contact between Elastic Bodies with an Elliptic Contact Interface in Torsion,” ASME Journal of Applied Mechanics, in press.
6. Ishikawa, Y., and Suda, M., 1986, “Differential Slipping Friction of a Ball Rolling in a V-Shaped Groove,” Journal of JSLE International Edition, No. 7, pp. 29-34.
7. Knight, B. F., 1990, “Development of a Testbed for Precision Linear Motion,” MS Thesis, Department of Mechanical and Aerospace Engineering, North Carolina State University.
8. Lin, M. C., Ravani, B., and Velinsky, S.A., 1994, “Kinematics of the Ball Screw Mechanism,” ASME JOURNAL OF MECHANICAL DESIGN, Vol. 116, pp. 849-855.
9. Mindlin, R. D., 1949. “Compliance of Elastic Bodies in Contact,” ASME Journal of Applied Mechanics, Vol. 71, pp. 259-268.
10. Otsuka, Jiro, 1992, “Nanometer Level Positioning using Three Kinds of Lead Screws,” Nanotechnology, Vol. 3, pp. 29-36.
11. Timoshenko, S. P., and Goodier, J. N., 1970, Theory of Elasticity, Third Edition, McGraw-Hill Book Company, New York, NY, pp. 409-420.