In-process monitoring method for machining environment based on simultaneous multiphenomena sensing

CIRP Annals - Manufacturing Technology

Volumn 46, Issue 1, 1997, Pages

  Shinno, H ^a   Hashizume, H ^a  

^a TOKYO INSTITUTE OF TECHNOLOGY   (Japan)

Author keywords

Cutting; In process monitoring; Multifunctional sensor

Indexed keywords

COMPUTER SIMULATION; CONCURRENT ENGINEERING; CUTTING; DATA ACQUISITION; PROCESS CONTROL; SENSORS;

IN-PROCESS MONITORING METHOD; INTELLIGENT MANUFACTURING SYSTEMS; MULTIFUNCTIONAL SENSOR;

MACHINING;

EID: 0030680851     PISSN: 00078506     EISSN: None     Source Type: Journal    
DOI: 10.1016/s0007-8506(07)60774-4     Document Type: Article

References (6)

1. Iwata, K. and Moriwaki, T., 1977, "An Application of Acoustic Emission Measurement to In-Process Sensing of Tool", Annals of the CIRP, 26-1:21-26.
2. Lai, T., Saito, Y. and Ito, Y., 1984, "Detection of Tool Wear through Dynamic Component of Cutting Force", (in Japanese), Journal of the JSPE, 50-7:1117-1122.
3. Micheletti, G.F., Koenig, W. and Victor, H.R., 1976, "In-Process Tool Wear Sensors for Cutting Operations", Annals of the CIRP, 25-1: 483-496.
4. Shinno, H., Hashizume, H. , Ito Y. and Sato, C., 1992, "Structural Configuration and Performances of Machining Environment-Controlled Ultraprecision Diamond Turning Machine 'Capsule'", Annals of the CIRP, 42-1:425-428.
5. Shinno, H., Rahman, M. and Inaba, C., 1992, "In-Process Monitoring System for Machining Environment Based on Heat Flux Sensing", JSME International Journal, 35-2:307-312.
6. Tlusty, J. and Andrews, G.C., 1983, "A Critical Review of Sensors for Unmanned Machining", Annals of the CIRP, 32-1:563-573.