Development of a high-performance deep-hole laser-guided boring tool: Guiding characteristics

CIRP Annals - Manufacturing Technology

Volumn 46, Issue 1, 1997, Pages 319-323

  Katsuki, A ^a   Onikura, H ^a   Sajima, T ^a   Rikimaru, M ^a  

^a KYUSHU UNIVERSITY   (Japan)

Author keywords

Adaptive control; Boring; Laser

Indexed keywords

ACTUATORS; ADAPTIVE CONTROL SYSTEMS; LASER APPLICATIONS; PIEZOELECTRIC DEVICES;

DEEP HOLE LASER GUIDED BORING TOOL;

BORING TOOLS;

EID: 0030649405     PISSN: 00078506     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0007-8506(07)60834-8     Document Type: Article

References (8)

1. Baier, J., Thai, T.P., 1981, Öldruckmessungen an BTA-Tiefbohrwerkzeugen, Ind. Anz., 103, 31-32.
2. Katsuki, A., Sakuma, K., Taguchi, K., Onikura, H., Akiyoshi, H., Nakamuta, Y.,1987, The influence of Tool Geometry on Axial Hole Deviation in Deep Drilling: Comparison of Single-and Multi-Edge Tools, JSME Int. J., Ser. II, 30, 1167-1174.
3. Katsuki, A., Onikura, H., Akashi, T., Nishimura, T., 1989, Study on Attitude Control of a BTA Boring Tool (1st Report, Construction of a System), Technology Reports of Kyushu University, (in Japanese), 62, 691-696.
4. Katsuki, A., Onikura, H., Sakuma, K., Taguchi, K., 1990, The Influence of a Boring Bar on Axial Hole Deviation in Deep Hole Drilling, Trans. Jpn. Soc. Mech. Eng., (in Japanese), 56, C, 1951-1959.
5. [5) Katsuki, A., Onikura, H., Sajima, T., Akashi, T., 1992, Development of a Deep-Hole Boring Tool Guided by Laser, Ann. CIRP, 41, 83-87.
6. Katsuki, A., Onikura, H., Sajima, T., Machida, S.,Oda, K., 1994, Development of a Deep-Hole Laser-Guided Boring Tool: The Boring of Workpieces with a Thin Wall and Inclined Prebored Hole, Prec. Eng., 16, 296-301.
7. Katsuki, A., Onikura, H., Sajima, T., Yamashita, Y., Ide, N., Saisho, K., Ikeda, K., 1996, Development of a Deep-Hole Laser-Guided Boring Tool Using Piezoelectric Translators, J. Jpn. Soc. Pre. Eng., (in Japanese),62, 994-998.
8. Pfleghar, F., 1976, Meßeinrichtung zur Untersuchung der Öldruckverteilung an Einlippen-Tiefbohrwerkzeugen, Ind. Anz., 98, 1220-1221.