Feasibility study on oil droplet flow investigations inside aero engine bearing chambers—pdpa techniques in combination with numerical approaches

Journal of Engineering for Gas Turbines and Power

Volumn 118, Issue 4, 1996, Pages 749-755

  Glahn, A ^a   Kurreck, M ^a   Willmann, M ^a   Wittig, S ^a  

^a UNIVERSITY OF KARLSRUHE   (Germany)

Author keywords

[No Author keywords available]

Indexed keywords

BEARINGS; DROPLETS; ENGINES-JET; FLOW; OILS;

EID: 0030461426     PISSN: 07424795     EISSN: 15288919     Source Type: Journal    
DOI: 10.1115/1.2816990     Document Type: Article

References (18)

1. Bachalo, W. D., and Houser, M. J., 1984, “Phase Doppler Spray Analyzer for Simultaneous Measurements of Drop Size and Velocity Distributions,” Optical Engineering, Vol. 23, pp. 583-590.
2. Bachalo, W. D., and Sankar, S. V., 1994, “Factors Affecting the Measurement Resolution and Accuracy of the Phase Doppler Particle Analyzer,” presented at The Second International Conference on Fluid Dynamics Measurement and Its Applications, Beijing, China.
3. Glahn, A., and Wittig, S., 1995, “Two-Phase Air/Oil Flow in Aero Engine Bearing Chambers-Characterization of Oil Film Flows,” ASME Paper No. 95-GT-114; ASME Journal of Engineering for Gas Turbines and Power, Vol. 118, 1996, pp. 578-583.
4. Gosman, A. D., and Ioannides, E., 1983, “Aspects of Computer Simulation of Liquid-Fueled Combustors,” Journal of Energy, Vol. 7.
5. Hallmann, M., 1994, “Numerische Untersuchung der Gemischbildung in Verbrennungskraftmaschinen,” Dissertation, InstitutfürThermische Strömungsmaschinen, Universität Karlsruhe, Germany.
6. Hallmann, M., Scheurlen, M., and Wittig, S., 1995, “Computation of Turbulent Evaporating Sprays: Eulerian Versus Lagrangian Approach,” ASME Journal of Engineering for Gas Turbines and Power, Vol. 117, pp. 112-119.
7. Jakoby, R., Benz, E., Wiümann, M., and Wittig, S., 1994, “Phase Resolved LDV-Measurements in High-Speed Rotating Disk Systems With Orifices,” Proc. Fifth International Symposium on Transport Phenomena and Dynamics of Rotating Machinery, Honolulu, HI, May 8-11, Vol. A, pp. 573-591.
8. Kurreck, M., and Wittig, S., 1994, “Numerical Simulation of Combustor plows on Parallel Computers-Potential, Limitations and Practical Experience,” ASME Paper No. 94-GT-404.
9. Noll, B., and Wittig, S., 1991, “Generalized Conjugate Gradient Method for the Efficient Solution of Three-Dimensional Fluid Flow Problems,” Numerical Heat Transfer, Vol. 20, pp. 207-221.
10. Noll, B., 1992, “Evaluation of a Bounded High-Resolution Scheme for Combustor Flow Computations,” AIAA Journal, Vol. 30, pp. 64-69.
11. Saffmann, M., 1989, “Phasen Doppler Methode zur optischen PartikelgrÖ/?enm-essung,” Technisches Messen, Vol. 56, pp. 298-303.
12. van der Hulst, H, C., 1981, Light Scattering by Small Particles, Dover, New York.
13. Waschka, W., Wittig, S., Scherer, Th., and Kim, S., 1991, “Leakage Loss and Heat Transfer in High-Speed Rotating Labyrinth Seals: An Experimental Verification of Numerical Codes,” Proc. 1991 Yokohama International Gas Turbine Congress, Vol. II, pp. 239-247.
14. Waschka, W., Scherer, Th., Kim, S., and Wittig, S., 1992a, “Study of Heat Transfer and Leakage in High-Rotating Stepped Labyrinth Seals” presented at the 4th International Symposium on Transport Phenomena and Dynamics of Rotating Machinery, Honolulu, HI.
15. Waschka, W., Wittig, S., and Kim, S., 1992b, “Influence of High Rotational Speeds on the Heat Transfer and Discharge Coefficients in Labyrinth Seals,” ASME Journal of Turbomachinery, Vol. 114, pp. 462-468.
16. Wittig, S., Glahn, A., and Himmelbach, J., 1994, “Influence of High Rotational Speeds on Heat Transfer and Oil Film Thickness in Aero Engine Bearing Chambers,” ASME Journal of Engineering for Gas Turbines and Power, Vol. 116, pp. 395-401.
17. Wittig, S., Kim, S., Jakoby, R., and Weiert, I., 1995, “Experimental and Numerical Study of Orifice Discharge Coefficients in High-Speed Rotating Disks,” ASME Journal of Turbomachinery, Vol. 118, pp. 400-407.
18. Zimmermann, H., Kämmerer, A., Fischer, R., and Rebhahn, D., 1991, “Two-Phase Flow Correlations in Air/Oil Systems of Aero Engines,” ASME Paper No. 91-GT-54.