Prediction of cutting forces and built-up edge formation conditions in machining with oblique nose radius tools

Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture

Volumn 210, Issue 5, 1996, Pages 457-469

  Arsecularatne, J A ^a,b   Fowle, R F ^b   Mathew, P ^b   Oxley, P L B ^b  

^a ASME

^b UNIVERSITY OF NEW SOUTH WALES   (Australia)

Author keywords

Built up edge; Cutting forces; Oblique machining theory

Indexed keywords

BUILT UP EDGE FORMATION CONDITIONS; CHIP FORMATION; CUTTING FORCES; OBLIQUE NOSE RADIUS TOOLS;

CUTTING TOOLS; HEAT TRANSFER; LOADS (FORCES); MATHEMATICAL MODELS; PROCESS CONTROL; SHEAR STRESS; STRAIN; THERMODYNAMIC PROPERTIES;

MACHINING;

EID: 0030357464     PISSN: 09544054     EISSN: None     Source Type: Journal    
DOI: 10.1243/PIME_PROC_1996_210_143_02     Document Type: Article

References (10)

1. Oxley, P. L. B. The mechanics of machining: an analytical approach to assessing machinability, 1989 (Ellis Horwood, Chichester).
2. Merchant, M. E. Basic mechanics of the metal cutting process. Trans. ASME, 1944, 66, 168-175.
3. Stabler, G. V. The fundamental geometry of cutting tools. Proc. Instn Mech. Engrs, 1951, 165, 14-26.
4. Lin, G. C. I., Mathew, P., Oxley, P. L. B. and Watson, A. R. Predicting cutting forces for oblique machining conditions. Proc. Instn Mech. Engrs, 1982, 196, 141-148.
5. Hu, R. S., Mathew, P., Oxley, P. L. B. and Young, H. T. Allowing for end cutting edge effects in predicting forces in bar turning with oblique machining conditions. Proc. Instn Mech. Engrs, Part C, 1986, 200(C2), 89-99.
6. Young, H. T., Mathew, P. and Oxley, P. L. B. Allowing for nose radius effects in predicting the chip flow direction and cutting forces in bar turning. Proc. Instn Mech. Engrs, Part C, 1987, 201(C3), 213-226.
7. Arsecularatne, J. A., Mathew, P. and Oxley, P. L. B. Prediction of chip flow direction and cutting forces in oblique machining with nose radius tools. Proc. Instn Mech. Engrs, Part B, 1995, 209(B4), 305-315.
8. Wang, J. and Mathew, P. Development of a general tool model for turning operations based on a variable flow stress theory. Int. J. Mach. Tools Mfg, 1995, 35(1), 71-90.
9. Mathew, P. A theoretical and experimental investigation of the mechanics of machining. PhD thesis, The University of New South Wales, 1983.
10. Hastings, W. F., Stevenson, M. G. and Oxley, P. L. B. Predicting a material's machining characteristics using flow stress properties obtained from high-speed compression tests. Proc. Instn Mech. Engrs, 1974, 188, 245-252.