Water flow studies using split-film anemometry

Measurement Science and Technology

Volumn 7, Issue 10, 1996, Pages 1529-1535

  Al Deen, M F N ^a   Samways, A L ^a   Bruun, H H ^a  

^a UNIVERSITY OF BRADFORD   (United Kingdom)

Author keywords

[No Author keywords available]

Indexed keywords

ANEMOMETERS; CALIBRATION; FLOW OF WATER; PROBES;

SIGNAL ANALYSIS TECHNIQUE; SINGLE NORMAL PROBES; SPLIT FILM PROBE ANEMOMETRY; X HOT FILM PROBES;

FLOW MEASUREMENT;

ANEMOMETERS-SPLIT FILM; FLOW MEASUREMENT;

EID: 0030266233     PISSN: 09570233     EISSN: None     Source Type: Journal    
DOI: 10.1088/0957-0233/7/10/022     Document Type: Article

References (16)

1. Bunco P H and Sandborn V A 1973 Use of the split-film sensor to measure turbulence in water near a wall Proc. Symp. on Turbulence in Liquids (University of Missouri, Rolla) pp 403-13
2. Boerner T and Leutheusser H J 1984 Calibration of split-fibre probe for use in bubbly two-phase flow DISA Inf. (29) 10-13
3. Bruun H H 1995 Hot-wire Anemometry. Principle and Signal Analysis (Oxford: Oxford University Press)
4. Duncan A and Hartmann U 1985 Some experiments on the dynamic behavior of a split-film probe Herman Fottinger Institut fur Thermo-und Fluidynamike T U Berlin, Institutbericht Nr 01/85
5. Farrar B, Samways A L, Ali J and Bruun H H 1995 A computer based hot-film technique for two-phase flow measurements Meas. Sci. Technol 6 1528-37
6. Hartmann U and Dengel P 1989 On turbulence measurements with a split-film probe Advances in Turbulence vol 2, ed H H Fernholz and H E Fiedler (Berlin: Springer) pp 262-6
7. Kiya M and Sasaki K 1985 Structure of a turbulent separation bubble J. Fluid Mech. 137 83-113
8. Olin J G and Kiland R B 1970 Split-film anemometer sensors for three-dimensional velocity-vector measurements Proc. Symp. on Aircraft Wake Turbulence (Seattle, Washington) pp 57-79
9. Ra S H, Chang P K and Park S O 1990 A modified calibration technique for the split-film sensor Meas. Sci. Technol. 1 1156-61
10. Richter H 1985 Measurement of two-dimensional periodical flow behind turbine guide-vanes by means of a split-fibre probe DANTEC Inf. (1) 10-12
11. Samways A L, Ali J, Al-Deen M F N and Bruun H H 1994 The calibration and measurements with cylindrical hot-film probes in water flows Meas. Sci. Technol. 5 1554-9
12. Shook M, Stock D E and Bowen A J 1990 Split-film anemometry ASME Proc. Symp. on Heuristics of Thermal Anemometry, FED 97 (University of Toronto) pp 93-8
13. Spenser B W and Jones B G 1971 Turbulence measurements with the split-film anemometer probe Proc. Symp. on Turbulence in Liquids (University of Missouri, Rolla) pp 7-15
14. Stock D E and Jaballa T M 1985 Turbulence measurements using split-film anemometry. Proc. Int. Symp. Refined Flow Modeling and Turbulence Measurements (University of Iowa) H 15 1-10
15. Stock D E, Wells M R, Barriqe A and Crowe C T 1977 Application of split-film anemometry to low speed flows with high turbulence intensity and recirculated as found in electrostatic precipitators Proc. Fifth Biennal. Symp. on Turbulence (University of Missouri, Rolla) pp 117-23
16. Wu S and Bose N 1994 An extended power law model for the calibration of hot-wire/hot-film constant temperature probes Int. J. Heat Mass Transfer 37 437-42