A study on sliding accuracy characteristics of an externally pressurized gas-lubricated guide way (Fundamental sliding accuracy characteristics)

JSME International Journal, Series C: Dynamics, Control, Robotics, Design and Manufacturing

Volumn 39, Issue 2, 1996, Pages 371-377

  Yabe, Hiroshi ^a   Ikuno, Yasuyuki ^a  

^a KYOTO UNIVERSITY   (Japan)

Author keywords

Accuracy; Design Engineering; Gas Lubrication; Groove Compensation; Guide Way; Hydrostatic Bearing; Machining Error; Precision Design; Sliding Accuracy

Indexed keywords

GASES; HYDROSTATIC BEARINGS; JOURNAL BEARINGS; LUBRICATION; MACHINING; NUMERICAL ANALYSIS; PRECISION ENGINEERING; PRESSURE EFFECTS; RHEOLOGY; SURFACES; SYSTEMS ENGINEERING;

EXTERNALLY PRESSURIZED GAS LUBRICATED GUIDE WAY; FLOATING HEIGHT VARIATION; GAS LUBRICATION; MACHINING ERROR; PITCHING MODE ANGULAR FLUCTUATION; PRECISION DESIGN; SLIDING ACCURACY CHARACTERISTICS;

BEARING PADS;

BEARINGS-HYDROSTATIC; GUIDEWAYS; LUBRICATION-GAS; SLIDING;

EID: 0030175840     PISSN: 13408062     EISSN: None     Source Type: Journal    
DOI: 10.1299/jsmec1993.39.371     Document Type: Article

References (5)

1. Yabe, H. and Watanabe, N., A Study on Running Accuracy of an Externally Pressurized Gas Thrust Bearing (Load Capacity Fluctuation Due to Machining Errors of the Bearing), JSME Int. J., Ser. III, Vol. 31, No. 1 (1988), p. 114.
2. Yabe, H. and Ishida, H., A Study on Running Accuracy of an Externally Pressurized Gas Thrust Bearing (Rotor Run-Out Characteristics), JSME Int. J., Ser. III, Vol. 34, No. 3 (1991), p. 333.
3. Yabe, H., A Study on Run-Out Characteristics of Externally Pressurized Gas Journal Bearing (Rotor Run-Out Characteristics), JSME Int. J., Ser. C, Vol. 37, No. 2 (1994), p. 355.
4. Yabe, H. and Matsuda, H., A Study on Run-Out Characteristics of Externally Pressurized Gas Journal Bearing (Influence of Factors Related to Run-Out Characteristics) (in Japanese), Trans. of JSME, Ser. C, Vol. 59, No. 567 (1993), p. 3506.
5. Kogure, K., Kaneko, R. and Ohtani, K., A Study on Characteristics of Surface -Restriction Compensated Gas Bearing with T-Shaped Grooves, Bull. of JSME, Vol. 25, No. 210 (1982), p. 2039.