The effect of polymer additives on extrusion slot coating

Chemical Engineering Science

Volumn 51, Issue 12, 1996, Pages 3289-3297

  Ning, Cheng Yu ^a   Tsai, Chin Chin ^a   Ta Jo, Liu ^a  

^a NATIONAL TSING HUA UNIVERSITY   (Taiwan)

Author keywords

[No Author keywords available]

Indexed keywords

COATINGS; EFFECTS; ELASTICITY; MOLECULAR STRUCTURE; POLYMERS; POWDERS; RHEOLOGY;

EXTRUSION SLOT COATING; FLUID ELASTICITY;

ADDITIVES;

EID: 0030158972     PISSN: 00092509     EISSN: None     Source Type: Journal    
DOI: 10.1016/0009-2509(95)00396-7     Document Type: Article

References (8)

1. Bauman, T., Sullivan, T. and Middleman, S., 1982, Ribbing instability in coating flow: effect of polymer additives. Chem. Engng Commun. 14, 35-46.
2. Gutoff, E. G. and Kendrick, C. E., 1987, Low flow limits of coating on a slide coateer. A.I.Ch.E. J. 33, 141-145.
3. Higgins, B. G. and Scriven, L. E., 1980, Capillary pressure and viscous pressure drop set bounds on coating bead operatibility. Chem. Engng Sci. 35, 673-682.
4. Kang, Y. T., Lee, K. Y. and Liu, T. J., 1991, The effect of polymer additives on the performance of two-roll coater. J. Appl. Polym. Sci. 43, 1187-1195.
5. Lee, K. Y., Liu, L. D. and Liu, T. J., 1992, Minimum wet thickness in extrusion slot coating. Chem. Engng Sci. 47, 1703-1713.
6. Ning, C. Y., 1995, The effect of polymer additives on extrusion slot coating flow. M.S. thesis, National Tsing Hua University, Taiwan.
7. Ruschak, K. J., 1976, Limiting flow in a pre-metering coating device. Chem. Engng Sci. 31, 1057-1060.
8. Yu, W. J., Liu, T. J. and Yu, T. A., 1995, Reduction of minimum wet thickness in extrusion slot coating. Chem. Engng Sci. 50, 917-920.