On the extent of stretching during deep drawing

Journal of Materials Processing Technology

Volumn 59, Issue 4, 1996, Pages 386-390

  Qin, S ^a   Shang, H M ^a   Tay, C J ^a   Mo, J X ^a  

^a NATIONAL UNIVERSITY OF SINGAPORE   (Singapore)

Author keywords

Deep drawing; Stretching

Indexed keywords

DEEP DRAWING; SHEET METAL;

BLANK DIAMETER; BLANK HOLDING LOAD; DRAWABILITY; PUNCH NOSE RADIUS;

STRETCHING;

EID: 0030157439     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/0924-0136(95)02169-8     Document Type: Article

References (4)

1. P.K. Lee, C.Y. Choi and T.C. HsÜ, Effect of draw-in on formability in axisymmetrical sheet metal forming, Trans. ASME B, 94(4) (1973) 925-930.
2. P.K. Lee, An analysis of the effect of process parameters on the formability of sheet metal, PhD Thesis, Univeristy of Aston, Birmingham, Gosta Green, Birmingham B4 7ET, UK, 1972.
3. H.M. Shang, F.S. Chau, C.J. Tay and S.L. Toh, An approximate solution for the hydrostatic bulging of circular diaphragms with draw-in allowed, J. Mech. Work. Technol., 13 (1986) 279-289.
4. S.Y. Chung and H.W. Swift, Cup-drawing from a flat blank: Part I, Experimental Investigation, Proc. Inst. Mech. Eng., 165 (1951) 199-211.