Cyclic stress-strain response and dislocation substructure evolution of a ferrite-austenite stainless steel

Acta Materialia

Volumn 44, Issue 3, 1996, Pages 1143-1153

  Mateo, A ^a   Llanes, L ^a   Iturgoyen, L ^a,b   Anglada, M ^a  

^a UNIVERSITAT POLITÈCNICA DE CATALUNYA   (Spain)

^b Sintermetal SA   (Spain)

Author keywords

[No Author keywords available]

Indexed keywords

COMPOSITION; CRYSTAL STRUCTURE; DEFORMATION; DISLOCATIONS (CRYSTALS); DYNAMIC RESPONSE; FATIGUE TESTING; STRAIN; STRAIN HARDENING; STRAIN RATE; STRESSES; TRANSMISSION ELECTRON MICROSCOPY; VOLUME FRACTION;

CONSTANT TOTAL STRAIN RATE; CYCLE DEFORMATION MECHANISM; CYCLIC STRESS STRAIN RESPONSE; DISLOCATION SUBSTRUCTURE; FERRITE AUSTENITE STAINLESS STEEL; PLASTIC STRAIN AMPLITUDE; REVERSED TOTAL STRAIN CONTROL;

STAINLESS STEEL;

EID: 0030110033     PISSN: 13596454     EISSN: None     Source Type: Journal    
DOI: 10.1016/1359-6454(95)00197-2     Document Type: Article

References (31)

1. H. D. Solomon and T. D. Devine Jr, in Duplex Stainless Steels (edited by R. A. Lula), p. 693. ASM, St Louis. MO, U.S.A. (1983).
2. R. W. Hayden and S. Floreen, Metall. Trans. 4, 561 (1973).
3. J. Wasén, B. Karlsson and M. Nyström, in Fatigue '90. Proc. Fourth Int. Conf. on Fatigue and Fatigue Thresholds (edited by H. Kitagawa and T. Tanaka), p. 1167. MCEP, Honolulu, Hawaii, U.S.A. (1990).
4. J. Wasén, E. U. Engström and B. Karlsson, in Stainless Steel '87, p. 357. The Institute of Metals, London, U.K. (1987).
5. R. Murakami, Y. H. Kim and W. G. Ferguson, Fatigue Fract. Engng Mater. Struct. 14, 741 (1991).
6. T. J. Marrow, Ph.D. thesis, Cambridge University, U.K. (1991).
7. L. Iturgoyen, Ph.D. thesis, Universidad Politécnica de Cataluña, Spain (1994).
8. T. Magnin and J. M. Lardon, Mater. Sci. Engng A104, 21 (1988).
9. T. Magnin, J. M. Lardon and L. Coudreuse, in Low Cycle Fatigue (edited by H. D. Solomon, G. R. Halford, L. R. Kaisand and B. N. Leis), ASTM STP 942, p. 812. ASTM, Philadelphia, PA (1988).
10. T. Magnin, T. Driver, J. Lepinoux and L. P. Kubin, Rev. Phys. Appl. 19, 467 (1984).
11. M. Anglada, M. Nasarre and J. A. Planell, in Stainless Steel '87, p. 474. The Institute of Metals, London, U.K. (1987).
12. M. Gerland, J. Mendez, P. Violan and B. Ait Saadi, Mater. Sci. Engng A118, 83 (1989).
13. C. Zhong, N. Y. Jin, X. Zhou, E. Meng and X. Chen, Acta metall. mater. 38, 2135 (1990).
14. N. Y. Jin, C. Zhong and X. Chen, Acta metall. mater. 38, 2141 (1990).
15. J.-B. Vogt, J. Foct, C. Regnard, G. Robert and J. Dhers, Metall. Trans. A 22A, 2385 (1991).
16. Y.-F. Li, Ph.D. thesis, University of Pennsylvania, PA (1991).
17. Y. B. Xia and Z. G. Wang. Mater. Sci. Engng A151, 29 (1992).
18. J. Polák, T. Kruml and S. Degallaix, Scripta metall. 29, 1553 (1993).
19. S. E. Fielding and W. M. Stobbs, J. Microsc. 130, 279 (1983).
20. B. D. Yan, A. S. Cheng, L. Buchinger, S. Stanzl and C. Laird, Mater. Sci. Engng 80, 129 (1986).
21. C. Laird, S. Stanzl, R. De La Veaux and L. Buchinger, Mater. Sci. Engng 80, 143 (1986).
22. L. Buchinger, A. S. Cheng, S. Stanzl and C. Laird, Mater. Sci. Engng 80, 155 (1986).
23. N. Salan and M. Anglada, unpublished results.
24. G. Wahlberg and G.L. Dunlop, in Stainless Steel '87, p. 291. The Institute of Metals, London, U.K. (1987).
25. Y.-F. Li, G. C. Farrington and C. Laird, Acta metall. mater. 41, 723 (1993).
26. M. Blicharski, Metal Sci. 18, 92 (1984).
27. J.-O. Nilsson, Scripta metall. 17, 593 (1983).
28. T. Magnin and J. H. Driver. Mater. Sci. Engng 39, 175 (1979).
29. T. Magnin, L. Coudreuse and A. Fourdeux, Mater. Sci. Engng 63, L5 (1984).
30. G. Aggen, H. E. Deverell and J. J. Nichol, in Proc. of MiCon 78: Optimization and Processing Properties and Service Performance through Microstructural Control (edited by H. Abrams, G. N. Maniar, D. A. Nail and H. D. Solomon). ASTM STP 672. p.334. ASTM, Philadelphia, PA (1979).
31. W. C. Leslie, The Physical Metallurgy of Steels, p. 121. McGraw Hill, Tokyo, Japan (1982).