Inverse error analysis for multi-axis machines

Journal of Manufacturing Science and Engineering, Transactions of the ASME

Volumn 118, Issue 1, 1996, Pages 88-94

  Lin, P D ^a   Ehmann, K F ^b  

^a NATIONAL CHENG KUNG UNIVERSITY   (Taiwan)

^b Northwestern University   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

ERROR ANALYSIS; FITS AND TOLERANCES; INVERSE PROBLEMS; MOTION CONTROL; PARAMETER ESTIMATION; POSITION CONTROL;

ALLOWABLE TOLERANCE LIMITS; INVERSE ERROR ANALYSIS; MAXIMUM ALLOWABLE TOLERANCE; MULTIAXIS MACHINES;

MECHANISMS;

EID: 0030084175     PISSN: 10871357     EISSN: 15288935     Source Type: Journal    
DOI: 10.1115/1.2803651     Document Type: Article

References (10)

1. Benhabib, B., Fenton, R. G., and Goldenberg, A. A., 1987, “Computer-Aided Joint Error Analysis of Robots,” IEEE Journal of Robotics and Automation, Vol. RA-3, No. 4, pp. 317-322.
2. Chase, K. W., and Greenwood, W. H., 1986, “Computer-Aided Tolerance Selection,” CATS User guide. ADCATS Report No. 86-2, Brigham Young University.
3. Fortini, E. T., 1967, Dimensioning for Interchangeable Manufacturing, Industrial Press, pp. 48.
4. Lin, P. D., 1989, “Error Analysis, Measurement and Compensation for Multiaxis Machines,” Ph.D. Thesis, Mechanical Engineering Department, Northwestern University.
5. Lin, P. D., and Eman, K. F., 1988, “Real-time Compensation of Geometrical and Kinematic Errors of a Multi-axis Machine,” Proceedings of the USA-Japan Symposium on Flexible Automation. Minneapolis, Minnesota, pp. 1069-1074.
6. Lin, P. D., and Ehmann, K. F., 1993, “Direct Volumetric Error Evaluation for Multi-Axis Machines,” Int. Journal of Machine Tools and Manufacture, Vol. 33, No. 5, pp. 675-693.
7. Reshetov, D. N., and Portman, V. T., 1988, Accuracy of Machine Tools, ASME Press.
8. Speckhart, F. H., 1972, “Calculation of Tolerance Based on a Minimum Cost Approach,” ASME Journal of Engineering for Industry, Vol. 94, No. 2, pp. 447-453.
9. Spotts, M. F., 1973, “Allocation of Tolerances to Minimize Cost of Assembly,” ASME Journal of Engineering for Industry, Vol. 95, No. 3, pp. 762-764.
10. Spotts, M. F., 1978, “Dimensioning Stacked Assemblies,” Machine Design, pp. 60.