Effect of corrosive environment on the fatigue crack initiation and propagation behavior of Al 5454-H32

Journal of Materials Engineering and Performance

Volumn 5, Issue 1, 1996, Pages 78-83

  Khan, Z ^a  

^a KING FAHD UNIVERSITY OF PETROLEUM AND MINERALS   (Saudi Arabia)

Author keywords

Al 5454 H32; Aluminum alloys; Corrosion; Fatigue

Indexed keywords

AIR; COMPOSITION; CORROSION; CRACK INITIATION; CRACK PROPAGATION; CRACKS; FATIGUE OF MATERIALS; FRACTURE; LOADS (FORCES); MECHANICAL PROPERTIES; PITTING; SODIUM CHLORIDE;

ALUMINUM MAGNESIUM ALLOY; CORROSIVE ENVIRONMENT; FATIGUE CRACK INITIATION; FATIGUE CRACK PROPAGATION; FATIGUE LOADING; SURFACE PITS;

ALUMINUM ALLOYS;

EID: 0030083852     PISSN: 10599495     EISSN: None     Source Type: Journal    
DOI: 10.1007/BF02647273     Document Type: Article

References (20)

1. H.P. Chu, Fatigue Crack Propagation in a 5456-H117 Aluminum Alloy in Air and Sea Water, J. Eng. Mater. Technol. (Trans. ASME), 1974, p 261
2. E.J. Czyryca and M.G. Vassilaros, "Corrosion Fatigue of Marine Aluminum Alloys in Salt Water Environments," Paper No. 24, presented at Tri-Service Conference on Corrosion, Airforce Materials Laboratory, Wright Patterson Airforce Base, 1972
3. S.P. Flodder and W.H. Hartt, Corrosion Fatigue of 5086-H34 Aluminum in Sea Water, Proc. 4th Annual Conf. Ocean Thermal Energy Conversion, Section VII, Technical Information Center, Oak Ridge, TN, 1977, p41-45
4. R.E. Stoltz and R.M. Pelloux, Mechanisms of Corrosion Fatigue Crack Propagation in Al-Zn-Mg Alloys, Metall. Trans., Vol 3 (No. 9), 1972, p 2433
5. K. Endo, K. Komai, and Y. Watase, Cathodic Protection in Corrosion Fatigue of an Aluminum-Zinc-Magnesium Alloy, Proc. 19th Japan Congress on Materials Research (Kyoto), Society of Materials Science, Japan, 1976
6. R.E. Stoltz and R.M. Pelloux, Inhibition of Corrosion Fatigue in 7075 Aluminum Alloys, Corrosion, Vol 29 (No. 1), 1973, p 13-17
7. H.P. Chu and J.G. Macco, STP 642, ASTM 1977, p 223
8. G.C. Tu, R.Y. Hwang, and I.T. Chen, J. Mater. Sci., Vol 26, 1991, p 1375
9. T.W. Crooker, J. Basic Eng. Mater. Technol.. July 1973, p 150
10. C.P. Blankenship, Jr. and E.A. Starke, Jr., Fatigue Fract. Eng. Mater. Struct., Vol 14 (No. 1), 1991, p 103
11. D. Rhodes and J.C. Radon, Fatigue Fract. Eng. Maler. Struct., Vol 1, 1979, p 383
12. P.S. Pao et al., Corrosion, Vol 45 (No. 7), 1989, p 530
13. A.J. Feeny, J.C. McMillan, and R.P. Wei, Metall. Trans., Vol 1, 1970, p 1741
14. S. Kawai and K. Kasai, Trans. Jpn. Soc. Mech. Eng., Vol AJ1 (No. 461), 1985, p23
15. N.L. Person, Mater. Perform., Vol 14 (No. 12), 1975, p 22
16. D.W. Hoeppnner, STP 675, ASTM, 1979, p 841
17. G.S. Chen and D.J. Duquette, in Environment Assisted Fatigue, EGF 7, P. Scot, Ed., Mechanical Engineering Publications Limited, London, 1990, p 285
18. H. Bernstein and C. Loeby, J. Eng. Mater. Technol. (Trans. ASME), Vol 110, July 1988, p 235
19. R.A. Cottis, A. Markfield, and P. Hartopoulas, in Environment Assisted Fatigue, EGF 7, P. Scot, Ed., Mechanical Engineering Publications Limited, London, 1990, p 381
20. T. Magnin, in Environment Assisted Fatigue, EGF 7, P. Scot, Ed., Mechanical Engineering Publications Limited, London, 1990, p 309