The effects of geometric variables in roll forming a channel section

Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture

Volumn 210, Issue 2, 1996, Pages 127-134

  Zhu, S D ^a   Panton, S M ^a   Duncan, J L ^a  

^a UNIVERSITY OF AUCKLAND   (New Zealand)

Author keywords

Cold roll forming; Sheet metal forming

Indexed keywords

COLD ROLLING; DEFORMATION; EFFECTS; GEOMETRY; MATHEMATICAL MODELS; SHEET METAL; STRAIN;

BEND ANGLE; BEND ANGLE INCREMENT; CHANNEL SECTION; FLANGE LENGTH; LONGITUDINAL STRAIN;

ROLLING;

EID: 0029756737     PISSN: 09544054     EISSN: None     Source Type: Journal    
DOI: 10.1243/PIME_PROC_1996_210_098_02     Document Type: Article

References (14)

1. Panton, S. M., Zhu, S. D. and Duncan, J. L. Geometric constraints on the forming path in roll forming channel sections. Proc. Instn Mech. Engrs, Part B, 1992, 206(B2), 113-118.
2. Panton, S. M., Zhu, S. D. and Duncan, J. L. Fundamental deformation types and sectional properties in roll forming. Int. J. Mech. Sci., 1994, 36, 725-735.
3. Zhu, S. D. Theoretical and experimental analysis of roll forming. PhD thesis, University of Auckland, February 1993.
4. Mednikov, Yu. A. Length of the uniform transition zone and relative expansion of the edge when forming into tubes. Stal in English, 1963, No. 3, 300-303.
5. Bhattacharyya, D., Smith, P. D., Yee, C. H. and Collins, I. F. The prediction of deformation length in cold roll forming. J. Mech. Working Technol., March 1984, 9, 181-191.
6. Kiuchi, M. and Koudabashi, T. Proceedings of Third International Conference on Rotary metalworking processes, September 1984, pp. 423-436 (IFS Limited and North-Holland, Amsterdam).
7. Zhu, S. D., Panton, S. M. and Duncan, J. L. Geometric and material effects in the roll forming of channel sections. In Advanced sheet metal forming technology, 1992 (Shenyang, People's Republic of China).
8. Suzuki, H., Kiuchi, M and Nakajima, S. Experimental investigation on cold roll forming process. Rep. Inst. Ind. Sci., The University of Tokyo, September 1972, 22(2).
9. Kato, K. A basic study on cold roll forming technique. Nippon Kokan Kubushi Kaisha Technical Report Overseas, June 1963, pp. 44-54.
10. Ditges, G. Rohrprofilierung als summe verschiedenartiger einzelformanderungen. Bender Bleche Rohre, 1968, 9(4), 220-230.
11. Chiang, K. F. Cold roll forming. ME thesis, University of Auckland, August 1984.
12. Bhattacharyva, D. and Smith, P. D. The development of longitudinal strain in cold roll forming and its influence on product straightness. Advanced Technol. Plasticity, 1984, 1, 422-427.
13. Kokado, J. and Onoda, Y. On longitudinal curvature and transition of strain of sheet steel in forming a groove with wide flange by cold roll forming. Kyoto University, Faculty of Engineering, Memoirs, October 1974, 36(4), 443-457.
14. Looi, B. C. A study of cold roll forming. Mechanical Engineering Project Report ME 32, University of Auckland, 1983.