Assessment of the creep response of new powder metallurgy-rapid solidification Al-Si-Ni-Cr and Al-Si-Cu-Fe alloys

Materials Science Forum

Volumn 217-222, Issue PART 3, 1996, Pages 1423-1428

  Evangelista, E ^a   Kloc, L ^b   Spigarelli, S ^a   Cerri, E ^a  

^a UNIVERSITÀ POLITECNICA DELLE MARCHE   (Italy)

^b INSTITUTE OF MATHEMATICS   (Czech Republic)

Author keywords

Aluminium Silicon alloys; Creep; Microstructure

Indexed keywords

CREEP; FRACTURE; MICROSTRUCTURE; POWDER METALLURGY; RAPID SOLIDIFICATION; STRENGTH OF MATERIALS;

CREEP FRACTURE; CREEP RATE DEPENDENCE; CREEP RESPONSE; CREEP STRENGTH; DUCTILE FRACTURE; PARTICLE MATRIX INTERFACES; RUPTURE;

ALUMINUM ALLOYS;

EID: 0029725404     PISSN: 02555476     EISSN: 16629752     Source Type: Book Series    
DOI: 10.4028/www.scientific.net/msf.217-222.1423     Document Type: Article

References (10)

1. M. Sukimoto, I. Iwai, I. Murase: "Development of high wear resistant Al-Si alloy", Proc. Conf. "Aluminum Technology '86", London (1986), The Institute of Metals, London, 557.
2. O.J. Sorheim, : Materials Science and Engineering, A134, 1115-1119, (1991).
3. J.H. Shih, J.Y. Wu, E.J. Lavernia: Scripta Metall. et Mater., 29, 31-36, (1993).
4. Y.W. Shin, G.A. Sargent, H. Conrad: Metall. Trans. A, 18A, 437, (1987).
5. I. Johansen, H.J. Rowen: Mat. Sci. and Engineering, A179/A180, 605, (1994).
6. A. Rajczy, A. Szombat, G. Bobok: "Economic heat treatment of cast Al-Si pistons satisfying specified critical properties" Proc. 4th Int. Conf. "Age Hardenable Aluminium Alloys", Balatonfured, Hungary, (1986), Materials Science Forum, Trans Tech Publications Ltd., Switzerland, 599, (1987).
7. L. Kloc, S. Spigarelli, E. Cerri, E. Evangelista, T.G. Langdon: submitted for publication.
8. N. Apaydin, R.W. Smith: Mater. Sci. and Eng., 98, 149, (1988).
9. J.C.M. Li: Acta Metall., 11, 1269, (1963).
10. A.K. Mukherjee: "High Temperature Creep", in Treatise on Materials Science and Technology", R.J. Arsenault ed., 6, Academic Press, New York, 164, (1975).